Lorex cvc2032 Mode D'Emploi
CVC2032 – INDOOR B&W DOME CAMERA
Overview
•
Polycarbonate housing provides high impact
protection against possible vandalism
• Smoked camera housing provides
unobtrusive appearance
• 1/3” CCD B&W image sensor with
polycarbonate dome housing
• Rotate camera 360 and/or Tilt camera 90
for optimal angle selection
• Built-in automatic back light compensation
• Smoked camera housing provides
unobtrusive appearance
• 1/3” CCD B&W image sensor with
polycarbonate dome housing
• Rotate camera 360 and/or Tilt camera 90
for optimal angle selection
• Built-in automatic back light compensation
Package Contents:
§ Check the package for the following contents
listed below.
Installation Instructions:
1. Open the dome by unscrewing the ring
counterclockwise
2. There are two mounting holes located on
the dome base. Use this to install the
dome on a wall, ceiling, etc
3. Apply power to the camera (using supplied
12V DC Adapter).
4. Connect the video cable to the BNC
connector (provided) if connecting to a
TV/Monitor or DVR with a BNC input.
5. Adjust the pan/tilt direction of the camera
for the desired picture view.
6. Close the dome by turning the ring
clockwise.
counterclockwise
2. There are two mounting holes located on
the dome base. Use this to install the
dome on a wall, ceiling, etc
3. Apply power to the camera (using supplied
12V DC Adapter).
4. Connect the video cable to the BNC
connector (provided) if connecting to a
TV/Monitor or DVR with a BNC input.
5. Adjust the pan/tilt direction of the camera
for the desired picture view.
6. Close the dome by turning the ring
clockwise.
Note: If you are using the RCA video cable to
connect the camera to a TV you must tune your
television to an auxiliary (AUX), A/V or video
mode to view the camera (Note: Consult the TV’s
Owner’s Manual for setting the TV to an auxiliary,
A/V or video mode.)
connect the camera to a TV you must tune your
television to an auxiliary (AUX), A/V or video
mode to view the camera (Note: Consult the TV’s
Owner’s Manual for setting the TV to an auxiliary,
A/V or video mode.)
CVC2032 – INDOOR B&W DOME CAMERA
Specifications
As our products are subject to continuous improvement,
SVII and its subsidiaries reserve the right to modify
product design, specifications and prices, without notice
and without incurring any obligation. E&OE.
SVII and its subsidiaries reserve the right to modify
product design, specifications and prices, without notice
and without incurring any obligation. E&OE.
Image
Sensor
Sensor
1/3" Interline transfer type
B&W CCD
B&W CCD
Effective
Pixels
Pixels
510H x 492V (250K)
Scanning
System
System
525 Lines 2:1 Interlace
Scanning
Frequency
Frequency
15.734KHz (H), 59.94Hz (V)
Resolution
380 TV-Lines
Shutter
Speed
Speed
1/60 ~ 1/100,000 sec.
S/N Ratio
More than 48dB (AGC off)
Sync.
System
System
Internal
Min.
Illumination 0.5 LUX (F2.0)
Gain Control Automatic
Video Output 1.0 Vp-p (75? load)
Lens
Illumination 0.5 LUX (F2.0)
Gain Control Automatic
Video Output 1.0 Vp-p (75? load)
Lens
Fixed (3.6mm)
Power
Supply
Supply
DC12V ± 10%
Power
Consumption<100mA (DC12V)
Operating
Temp
Consumption<100mA (DC12V)
Operating
Temp
-10 to +45 C / 14 to 113F
Operating
Humidity
Humidity
90% RH Max.
Diameter
125mm
Camera &
Bracket
Manual
Power
Supply