Cisco me 3400 Guide De Logiciel

Beginning in privileged EXEC mode, follow these steps to assign a Layer 2 Ethernet port to a Layer 2 
EtherChannel. This procedure is required.

Enter global configuration mode.

interface interface-id

Specify a physical port, and enter interface configuration mode.

Valid interfaces include physical ports.

For a PAgP EtherChannel, you can configure up to eight ports of 
the same type and speed for the same group.

For a LACP EtherChannel, you can configure up to 16 Ethernet 
ports of the same type. Up to eight ports can be active, and up to 
eight ports can be in standby mode.

If the interface is a UNI, you must enter the port-type 
{eni | nni} interface configuration command before 
configuring PAgP or LACP.

Enable the port, if necessary. By default, UNIs and ENIs are 
disabled, and NNIs are enabled.

switchport mode {access | trunk}

switchport access vlan vlan-id 

Assign all ports as static-access ports in the same VLAN, or 
configure them as trunks.

If you configure the port as a static-access port, assign it to only 
one VLAN. The range is 1 to 4094.