Cisco SRW208 Manuel D’Utilisation
Chapter 5
Advanced Configuration
19
8-Port 10/100 Ethernet Switch with Webview
Address Mode
Indicates whether the Switch is configured
with a Static or Dynamic IP address (configurable from
Setup - Network Settings tab).
Base MAC Address
This is the MAC address of the
Switch.
System Information
Serial Number
The serial number of the Switch is
displayed.
Model Name
The model name of the Switch is
displayed.
Hardware version
The current hardware version is
displayed.
Boot Version
The current boot version is displayed.
Firmware Version
The current software version is
displayed.
System Location
The system location is displayed here
(configurable from Setup > Network Settings tab).
System Contact
The contact person for this Switch
is displayed here (configurable from Setup > Network
Settings tab).
System Uptime
This displays the amount of time that
has elapsed since the Switch was last reset.
Current Time
The system time is displayed here
(configurable from Setup > Time tab).
PoE Information
Maximum Available Power
Indicates the maximum
amount of power the device can supply.
System Operation Status
Indicates whether the PoE
function is on or off.
Mainpower Consumption
Displays how much power is
currently used.
Setup > Network Settings
Setup > Network Settings
The Network Settings screen allows you to assign DHCP
or static IP settings to interfaces and assign default
gateways.
Identification
System Name
This field allows you to assign a system
name.
System Location
This field is used for entering a
description of where the Switch is located, such as 3rd
floor.
System Contact
Enter the administrative contact person
in this field.
System Object ID
The system object identifier is
displayed here.
Base MAC Address
This is the MAC address of the
Switch.
IP Configuration
Management VLAN
This drop-down allows you to select
the Management VLAN.
IP Address Mode
This drop-down allows you to select
Static or Dynamic IP address configuration.
Host Name
Enter the DHCP Host Name here.
IP Address
If using a static IP address, enter the IP address
here.
Subnet Mask
Enter the subnet mask of the currently
configured IP address.
Default Gateway
Enter the IP address of the Default
Gateway.