Alcatel-Lucent 6850-48 Guide De Réglage Du Réseau
Configuring VLAN Stacking
Configuring VLAN Stacking Services
OmniSwitch AOS Release 6 Network Configuration Guide
September 2009
page 9-15
The following command example configures the vendor TPID for NNI port 2/1 to 0x88a8 and enables
support for Spanning Tree legacy BPDU:
support for Spanning Tree legacy BPDU:
-> ethernet-service nni 2/1 tpid 88a8 stp legacy-bpdu enable
Consider the following when configuring NNI port parameter values:
• A mismatch of TPID values on NNI ports that are connected together is not supported; VLAN Stack-
ing will not work between switches using different NNI TPID values.
• Enable legacy BPDU support only on VLAN Stacking network ports that are connected to legacy
BPDU switches. Enabling legacy BPDU between AOS switches may cause flooding or an unstable
network.
network.
• If legacy BPDU is enabled on a network port while at same time BPDU flooding is enabled on user
ports, make sure that tagged customer BPDUs are not interpreted by intermediate switches in the
provider network.
provider network.
• If the peer switch connected to the VLAN Stacking network port supports the Provider MAC address
(i.e., STP, 802.1ad/D6.0 MAC), then enabling legacy BPDU support is not required on the network
port. Refer to the following table to determine the type of STP or GVRP MAC used:
port. Refer to the following table to determine the type of STP or GVRP MAC used:
• GVRP legacy BPDU are supported only on network ports that already have GVRP enabled for the
port.
• STP legacy BPDU are supported only when the flat Spanning Tree mode is active on the switch.
Use the
command to display the NNI port configuration for the switch.
Configuring a VLAN Stacking Service Access Point
SAP is assigned an ID number at the time it is configured. This ID number is then associated with the
following VLAN Stacking components:
following VLAN Stacking components:
• User Network Interface (UNI) ports. See
.
• Customer VLANs (CVLANs). See
.
• SAP profile. Each SAP is associated with a single profile. This profile contains attributes that are used
to define traffic engineering parameters applied to traffic ingressing on UNI ports that are associated
with the SAP. See
with the SAP. See
.
STP
Customer MAC
{0x01, 0x80, 0xc2, 0x00, 0x00, 0x00}
Provider MAC address (802.1ad/D6.0)
{0x01, 0x80, 0xc2, 0x00, 0x00, 0x08}
Provider MAC address (Legacy MAC)
{0x01, 0x80, 0xc2, 0x00, 0x00, 0x00}
GVRP
Customer MAC address
{0x01, 0x80, 0xc2, 0x00, 0x00, 0x21}
Provider MAC address
{0x01, 0x80, 0xc2, 0x00, 0x00, 0x0D}