Alcatel-Lucent 6850-48 Guide De Réglage Du Réseau
Configuring Static Link Aggregation
Application Example
OmniSwitch AOS Release 6 Network Configuration Guide
September 2009
page 22-11
Application Example
Static link aggregation groups are treated by the switch’s software the same way it treats individual physi-
cal ports. This section demonstrates this by providing a sample network configuration that uses static link
aggregation along with other software features. In addition, a tutorial is provided that shows how to
configure this sample network using Command Line Interface (CLI) commands.
cal ports. This section demonstrates this by providing a sample network configuration that uses static link
aggregation along with other software features. In addition, a tutorial is provided that shows how to
configure this sample network using Command Line Interface (CLI) commands.
The figure below shows VLAN 8, which has been configured on static aggregate 1 and uses 802.1Q
tagging. The actual physical links connect ports 4/1, 4/2, 4/3, and 4/4 on Switch A to port 2/41, 2/42, 2/43,
and 2/44 on Switch B.
tagging. The actual physical links connect ports 4/1, 4/2, 4/3, and 4/4 on Switch A to port 2/41, 2/42, 2/43,
and 2/44 on Switch B.
Sample Network Using Static Link Aggregation
Follow the steps below to configure this network:
Note. Only the steps to configure the local (i.e., Switch A) switch are provided here since the steps to
configure the remote (i.e., Switch B) switch would not be significantly different.
configure the remote (i.e., Switch B) switch would not be significantly different.
1 Configure static aggregate group 1 by entering static linkagg 1 size 4 as shown below:
-> static linkagg 1 size 4
2 Assign ports 4/1, 4/2, 4/3, and 4/4 to static aggregate group 1 by entering:
-> static agg 4/1 agg num 1
-> static agg 4/2 agg num 1
-> static agg 4/3 agg num 1
-> static agg 4/4 agg num 1
3 Create VLAN 8 by entering:
-> vlan 8
4 Configure 802.1Q tagging with a tagging ID of 8 on static aggregate group 1 (on VLAN 8) by enter-
ing:
ing:
-> vlan 8 802.1q 1
5 Repeat steps 1 through 4 on Switch B. All the commands would be the same except you would substi-
tute the appropriate port numbers.
tute the appropriate port numbers.
Note. Optional. Use the
command to display 802.1Q configurations.
Static Aggregate Group 1
VLAN 8 with 802.1Q tagging has
been configured to use this group.
been configured to use this group.
Switch B
Switch A