Fujitsu 3500 Mode D'Emploi

• The Stylistic 3500 battery pack uses Lithium ion battery cells which have no 

“memory effect.” You do not need to discharge the battery pack before you begin 
charging. 

Removing and Installing the Battery Pack

2

The battery pack can be removed from the pen tablet and swapped with a charged 
battery pack. The battery pack can then be charged in an external charger if one is 
available. To remove the battery pack from the pen tablet: 

1. Choose one of the following: 

• If a charged battery pack is available, you can suspend system operation. A 

built-in “bridge” battery will maintain the system in Suspend-to-RAM mode 
for about 5 minutes while the battery pack is removed; this allows time for 
replacement with a charged battery pack.

• If a charged battery pack is not available, save your work and close all 

running programs, then shut down the system or Save-to-Disk.

• Plug in an external DC power source.

2. Press and hold the battery release button. (See Figure 2-1.)

3. While holding the button, slide the battery release latch in the direction indicated 

in Figure 2-1. The edge of the battery pack lifts away from the surface of the 
system.

4. Remove the battery pack from the pen tablet. 

If you are using an external battery charger, refer to the instructions provided with 
the battery charger. 

To install the battery pack:

1. Orient the battery such that the battery connector is positioned over the connector 

in the empty battery pack tray. Lay the battery pack into the tray and press it 
firmly into the tray until it is seated. When it is properly seated, the battery release 
latch should move towards the battery release button. 

2. When the battery is firmly seated, press the battery release latch towards the 

battery release button until the release button pops up to the level of the system.    

Once the battery pack is installed, you can resume system operation or start your 
system and use the system normally.