AG Neovo f-315a Mode D'Emploi
32
Troubleshooting
Troubleshooting Procedures
This LCD monitor comes pre-adjusted with standard VGA timing. Due to
output timing differences among various VGA cards, you may initially
experience an unstable or unclear display when a new display mode or new
VGA card is selected.
Before applying any of the following troubleshooting procedures, you should
first press the AUTO
output timing differences among various VGA cards, you may initially
experience an unstable or unclear display when a new display mode or new
VGA card is selected.
Before applying any of the following troubleshooting procedures, you should
first press the AUTO
button to run the optimal adjustment option in the
OSD menu.
Warning Messages
Message
Solution
CAN NOT DISPLAY
THIS INPUT SIGNAL
THIS INPUT SIGNAL
The input signal is not acceptable by the monitor.
· Ensure that the video resolution and frequency
range are within that specified for the monitor.
(Refer to the “Technical Specifications” section
of this user’s manual for details.)
(Refer to the “Technical Specifications” section
of this user’s manual for details.)
NO SIGNAL INPUT
No signal input detected.
· Check that the power switch of your computer or
video source is in the “ON” position.
· Check that the video signal cable is properly
connected.
· Ensure that no pins are bent or pushed in the
video-input connector.
MAIN CONTROL
MENU LOCKED
MENU LOCKED
The main control menu (On-Screen Display menu) is
locked to avoid unwanted adjustment.
locked to avoid unwanted adjustment.
· Press and hold the DOWN
and AUTO
buttons together for 15 seconds to unlock the
main control menu.
main control menu.
ADJUSTING
FREQUENCY
ADJUSTING PHASE
ADJUSTING
POSITION
FREQUENCY
ADJUSTING PHASE
ADJUSTING
POSITION
The monitor is detecting the input signal and
automatically adjusting the monitor parameters
accordingly.
It takes around 5 seconds to finish the whole
process.
automatically adjusting the monitor parameters
accordingly.
It takes around 5 seconds to finish the whole
process.
· You are recommended to auto adjust by
pressing the
button every time you change
the resolution or refresh rate.