Printronix P5000LJ Guide D’Exploitation
76
Chapter
3
Configuring the P-Series Emulation with Control Codes
Attribute Set and Reset Codes
Certain print attributes are set and reset (turned on or off) by using the
appropriate SFCC code sequence and the numbers 1 or 0. These may be
either the hexadecimal code 01 and 00, or the ASCII code for the printable
symbols of decimal 1 and 0 (hexadecimal code 31 and 30, respectively).
Expanded Print, Super/Subscript Print, and Underline are attributes that are
set/reset this way.
appropriate SFCC code sequence and the numbers 1 or 0. These may be
either the hexadecimal code 01 and 00, or the ASCII code for the printable
symbols of decimal 1 and 0 (hexadecimal code 31 and 30, respectively).
Expanded Print, Super/Subscript Print, and Underline are attributes that are
set/reset this way.
NUL Code
NUL (hex 00) is ignored by the printer and can be used as a fill character;
however, it can not be used to add blank spaces since it is not a space
character.
however, it can not be used to add blank spaces since it is not a space
character.
Print Modes Supported for Character Sets
All print modes are supported for all character sets; however, for the character
sets listed in Table 16, only the print modes listed are supported.
sets listed in Table 16, only the print modes listed are supported.
Note
Hex 80 in the 0437 PC Character Set and hex 7F in the 0850 PC Character
Set are treated as a NUL; however, these two controls can not be used as
parameter terminators.
Set are treated as a NUL; however, these two controls can not be used as
parameter terminators.
Table 16. Print Modes Supported
Character Set
Mode
Pitch
Barcode 10 cpi
DP
10
Multinational DP 10 cpi
DP
10
Multinational DP 12 cpi
DP
12
Multinational NLQ 10 cpi
NLQ
10
Greek DP 10 cpi
DP
10
Greek DP 12 cpi
DP
12
Greek NLQ 10 cpi
NLQ
10
Graphic DP 10 cpi
DP
10
Graphic NLQ 10 cpi
NLQ
10
Scientific DP 10 cpi
DP
10
Scientific DP 12 cpi
DP
12
Scientific NLQ 10 cpi
NLQ
10
OCR-A
OCR-A
10
OCR-B
OCR-B
10