Printronix l7032 Guide D’Exploitation
Forms, Listing Dynamic (Version II)
95
DISK
Optional parameter to print the form stored in the
printer’s flash memory.
printer’s flash memory.
(cc)G
Terminator. Enter the SFCC for your VGL
configuration immediately followed by G, the
universal terminator, or another valid Graphics
Mode command terminator to end the data.
configuration immediately followed by G, the
universal terminator, or another valid Graphics
Mode command terminator to end the data.
Forms, Listing Dynamic (Version II)
Purpose
Lists all previously created forms including the form size, in bytes,
used by each form name.
used by each form name.
Mode
Graphics with an Extended Graphics Command selected
Format
(cc) IFORM,L (cc)G
(cc)
Represents the Special Function Control Code
(SFCC). Enter the specific SFCC for your VGL
configuration.
(SFCC). Enter the specific SFCC for your VGL
configuration.
IFORM,L
The command to list the forms in memory. Enter
IFORM,L.
IFORM,L.
(cc)G
Terminator. Enter the SFCC for your VGL
configuration immediately followed by G, the
universal terminator, or another valid Graphics
Mode command terminator to end the data.
configuration immediately followed by G, the
universal terminator, or another valid Graphics
Mode command terminator to end the data.
Forms, Predefined (Version II)
Purpose
Loads one of three predefined forms from memory (AIAG,
Primary Metals, and Odette). These forms are selected and
completed using the commands and legends described.
Primary Metals, and Odette). These forms are selected and
completed using the commands and legends described.
Mode
Graphics with standard Graphics Command selected
Format
(cc) IFORM,E
formname.QMS (cc)G
(cc)
Represents the Special Function Control Code
(SFCC). Enter the specific SFCC for your VGL
configuration.
(SFCC). Enter the specific SFCC for your VGL
configuration.
IFORM,E
formname.QMS
The command to retrieve the specified predefined
form. Enter IFORM,E
form. Enter IFORM,E
formname.QMS, where
formname ia AIAG, METALS, or ODETTE.
(cc)G
Terminator. Enter the SFCC for your VGL
configuration immediately followed by G, the
universal terminator, or another valid Graphics
Mode command terminator to end the data.
configuration immediately followed by G, the
universal terminator, or another valid Graphics
Mode command terminator to end the data.
Comments The IFORM,E command not only loads the desired predefined
form, but provides the means to fill out the form. The following
three examples show the method of specifying the data to be
placed on the forms.
three examples show the method of specifying the data to be
placed on the forms.