Printronix SL5000 Guide D’Exploitation
Plot, Odd Dot (P-Series XQ Normal Density Graphics
73
Plot, Odd Dot (P-Series XQ Normal Density Graphics
ASCII Code ENQ
Hex Code
05
Dec Code
5
Purpose
Selects odd dot plot mode to print dots in odd numbered dot
columns for normal density plotting.
columns for normal density plotting.
Comment
The Odd Dot Plot control code can occur anywhere in the data
line before the line terminator. It defines certain data between
the next and last paper motion commands as odd dot plot data.
These data are plotted at 60 by 72 dots per inch.
line before the line terminator. It defines certain data between
the next and last paper motion commands as odd dot plot data.
These data are plotted at 60 by 72 dots per inch.
When this mode is exited, the print mode and attributes last
selected remain active. A detailed description of plotting can be
found in Chapter 8, “Graphics.”
selected remain active. A detailed description of plotting can be
found in Chapter 8, “Graphics.”
This command can occur anywhere in the datastream and is
acted upon immediately, affecting the entire current print line.
acted upon immediately, affecting the entire current print line.
Example
Select Letter Gothic (DP)
ASCII Code STX
ETX
HT
Hex Code
02
03
09
Dec Code
2
3
9
Purpose
Selects Letter Gothic (DP) print mode.
NOTE: Configure this feature using the control panel.
Comment
Any of the three codes select Letter Gothic (DP) print mode.
Both ETX and HT also select 17.1 cpi if you configure the printer
from the control panel (see page 68).
from the control panel (see page 68).
These commands can occur anywhere in the datastream and
are acted upon immediately, affecting the entire current print
line.
are acted upon immediately, affecting the entire current print
line.