HTC mytouch 3g Mode D'Emploi
T-Mobile myTouch 3G User Guide
107
May 19, 2009
Note
Specifications are subject to change without prior notice.
10.2
A.2 Regulatory Notices
Regulatory Agency Identifications
For regulatory identification purposes, this product is assigned a model number of
For regulatory identification purposes, this product is assigned a model number of
SAPP300
.
To ensure continued reliable and safe operation of this product, use only the accessories listed below
with your
with your
SAPP300
.
The Battery Pack has been assigned a model number of
SAPP160
.
Note
This product is intended for use with a certified Class 2 Limited Power Source, rated 5 Volts DC,
maximum 1 Amp power supply unit.
Federal Communications Commission Notice
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful interference
to radio or TV reception, which can be determined by turning the equipment on and off, the user is
encouraged to try to correct the interference by one or more of the following measures:
•
(1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful interference
to radio or TV reception, which can be determined by turning the equipment on and off, the user is
encouraged to try to correct the interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
connected.
•
Consult the dealer or an experienced radio or television technician for help.
Modifications
The FCC requires the user to be notified that any changes or modifications made to the device that
are not expressly approved by High Tech Computer Corporation may void the user’s authority to
operate the equipment.
are not expressly approved by High Tech Computer Corporation may void the user’s authority to
operate the equipment.
Body-worn operation
This device was tested for typical body-worn operations with the back of the phone kept
1.5 cm
from
the body. To maintain compliance with FCC RF exposure requirements, use only belt-clips, holsters or
similar accessories that maintain a
similar accessories that maintain a
1.5 cm
separation distance between the user’s body and the back
of the phone, including the antenna. The use of belt-clips, holsters and similar accessories should not
AC adapter
Voltage range/frequency: 100 - 240V AC, 47/63 Hz
DC output: 5V and 1A
DC output: 5V and 1A
Special features
Digital Compass, G-Sensor