Toshiba 24SLV411U Manuel D’Utilisation

Removing the Pedestal Stand

1)  Carefully lay the front of the TV face down on a flat, 

cushioned surface such as a quilt or blanket. Leave 

the stand protruding over the edge of the surface.

2)  Remove the four screws shown in the below diagram. 

This will allow removal of the pedestal stand.

3)  Once you have removed all four screws, holding 

the pedestal stand in place, remove the pedestal 

stand from the TV.

CAUTION: Always place the TV on the floor or a 

sturdy, level, stable surface that can support the 

weight of the unit. To secure the TV, use a sturdy strap 

from the hook(s) on the rear of the TV to a wall stud, 

pillar, or other immovable structure. Make sure the 

strap is tight, secure, and parallel to the floor.

Notes on moisture condensation

Moisture condensation damages the unit. Please 

read the following carefully.

Moisture condensation occurs, for example, when 

you pour a cold drink into a glass on a warm day and 

drops of water form on the outside of the glass. In 

the same way, moisture may condense on this unit’s 

internal optical pick-up lens, one of the most crucial 

internal parts of the unit.

Moisture condensation may occur in the following 

situations:
•  When you move the unit from a cold area to a warm 

area.

•  When you use the unit in a room in which the heat 

was just turned on.

•  When you use the unit in an area where cold air 

from an air conditioner directly hits the unit.

•  When you use the unit in a humid area.

Never use the unit when moisture condensation may 

occur.

Using the unit when moisture condensation exists 

may damage discs and internal parts. Connect the 

power cord of the unit to the wall outlet, turn on the 

unit, remove the disc, and leave it for two or three 

hours. After two or three hours, the unit will have 

warmed up and evaporated any moisture. Leaving 

the TV connected to the wall outlet will help prevent 

moisture condensation in the unit.

Wall outlet

Four screws

VESA Mounting Pattern

VESA Mounting Pattern

VESA Mounting Pattern

Four screws

Four screws

Hook
Sturdy strap

(as short as possible)