Toshiba 32a12 Mode D'Emploi
13
Intr
oduction
Connecting
y
our T
V
Using the
Remote Contr
ol
Setting up
y
our T
V
Using the T
V
’s
F
eatur
es
Appendix
1
In the code table on page 14, find the code for your brand of VCR or
cable TV converter.
cable TV converter.
If more than one code is listed, try each one separately until you find
one that works.
one that works.
2
Set the TV/CABLE/VCR switch to VCR (for a VCR), or CABLE (for
a cable TV converter).
a cable TV converter).
3
While holding down RECALL, press the Channel Number buttons
to enter the 3-digit code for your brand of VCR or converter.
to enter the 3-digit code for your brand of VCR or converter.
4
To test the code, turn the VCR or converter on, point the remote
control at it, and press POWER.
control at it, and press POWER.
–If the correct code was entered, the VCR or converter will turn off.
–If the VCR or converter does not respond, repeat steps 1–4 using
another code.
–If the VCR or converter does not respond to a different code,
you will need to use the remote control that came with your VCR or
converter.
converter.
5
Set the TV/CABLE/VCR switch to TV to control the TV.
For future reference, write down the code(s) you used:
VCR Code:
Cable TV Converter Code:
Note:
You must reprogram the remote control every time the batteries are changed.
Some newer VCRs respond to either of two codes. These VCRs have a switch
labeled “VCR1/VCR2.” If your VCR has this kind of switch and does not respond
to the codes for your VCR brand, set the switch to the other position (“VCR1” or
“VCR2”) and reprogram the remote control.
labeled “VCR1/VCR2.” If your VCR has this kind of switch and does not respond
to the codes for your VCR brand, set the switch to the other position (“VCR1” or
“VCR2”) and reprogram the remote control.
Programming the remote control to operate a non-Toshiba VCR
or cable TV converter
or cable TV converter
Your Toshiba TV remote control is preprogrammed to operate Toshiba brand VCRs and cable TV converters. To
program your TV remote control to operate a non-Toshiba VCR or a cable TV converter, follow these steps:
program your TV remote control to operate a non-Toshiba VCR or a cable TV converter, follow these steps:
TV
CABLE
VCR
CABLE
VCR
MENU/
ENTER
CH RTN
RECALL
MUTE
CH
CH
VOL
VOL
1
4
7
2
5
8
3
6
9
0
ENT
100
POWER
o
REW
PAUSE
FF
SOURCE
STILL
PIP
SLOW
PIP CH
LOCATE
SWAP
STOP
PLAY
REC
TV/VCR
TV/VIDEO
FAV CH
A
CT-90037
EXIT
RECALL
Channel
Numbers
Numbers
POWER