Manualsbrain.com
  1. Manuels
  2. Marques
  3. Toshiba
  4. 32hf72
  5. Manuel Du Propriétaire

Toshiba 32hf72 Manuel Du Propriétaire

Télécharger
Page de 55
Intr
oduction
Connecting
y
our T
V
Using the
Remote Contr
ol
Setting up
y
our T
V
Using the T
V’s
F
eatur
es
Appendix
Index
15
(E) 32HF72 36HF72
1
2
3
4
5
6
7
8
9
ENT
100
0
CH
VOL
POWER
TIMER
RECALL
TV/VIDEO
MUTE
TV
CABLE
VCR
CH RTN
PIC SIZE
EXIT
LIGHT
STOP SOURCE
ADV/
PIP CH
ADV/
PIP CH
FAV
FAV
PLAY PIP
FAVORITE
MENU/
STROBE
ENTER
Programming the remote control for use with a
non-Toshiba VCR or a cable TV converter
The remote control is pre-programmed to operate Toshiba VCRs. To
use the remote control to operate a non-Toshiba VCR or cable
converter, follow the steps below to program the remote control.
1. Refer to the “VCR code table” or “Cable TV converter code
table” on pages 16–17 to find the corresponding code for your
VCR or cable TV converter brand.
If more than one code is listed, try each one separately until you
find the one that works.
2. If you are reprogramming the remote control to operate your:
• VCR: Set the TV/CABLE/VCR switch on the remote control
to VCR.
• Cable converter: Set the TV/CABLE/VCR switch on the
remote control to CABLE.
3. While holding down the RECALL button, press the Number
buttons (0–9) to enter the three-digit code for your VCR or cable
TV converter.
4. Point the remote control at the VCR or converter and press
POWER to test the code.
If the VCR or converter responds, you have entered the correct
code.
If the VCR or converter does not respond, you may have entered
the wrong code. Repeat steps 1–4 using another code.
5. Reset the TV/CABLE/VCR switch to TV to control the TV.
For future reference, write down the code(s) you used:
VCR code  ________________________________
Cable TV converter code  ____________________
Note:
• Each time you replace the batteries, you
must reprogram the remote control.
• Some newer VCRs are capable of working
on either of two remote codes. These VCRs
have a switch labeled “VCR1/VCR2.”
If your VCR has this kind of switch and
does not respond to any of the codes for
your VCR brand, set the switch to the other
position (VCR1 or VCR2) and reprogram
the remote control.
POWER
Channel 
yz
Channel
Number
Enter
RECALL