Toshiba 40rf350 Mode D'Emploi
44
RF350U (E/F) Web 213:276
Chapter 5: Setting up your TV
Viewing the digital signal meter
You can view the digital signal meter in the ANT digital TV
input source only.
input source only.
To view the digital signal meter:
1
Press Y and open the Setup menu.
2
Highlight Installation and press T.
3
A new set of Installation menu icons will appear, as shown
below. Open the Terrestrial menu, highlight Signal
Meter, and press T.
below. Open the Terrestrial menu, highlight Signal
Meter, and press T.
4
Press BbC c to select the antenna input and digital
channel whose signal you want to check.
channel whose signal you want to check.
Note: The physical digital channel number listed in the
Signal Meter screen may not correspond to a virtual TV
channel number. Contact your local broadcasters to
obtain the RF channel numbers for your local digital
stations.
Signal Meter screen may not correspond to a virtual TV
channel number. Contact your local broadcasters to
obtain the RF channel numbers for your local digital
stations.
To close the screen and return to the Terrestrial
menu:
menu:
Highlight Done and press T.
To return to normal viewing:
Press O.
Viewing the system status
To view the system status:
1
Press Y and open the Setup menu.
2
Highlight Installation and press T.
3
A new set of Installation menu icons will appear, as shown
below. Open the System Status menu, highlight
System Information, and press T.
below. Open the System Status menu, highlight
System Information, and press T.
4
Press C c to scroll through the menu bar to select the
Software Version and view the related information.
Software Version and view the related information.
To close the screen and return to the Installation
menu:
menu:
Highlight Done and press T.
To return to normal viewing:
Press O.
Reset Factory Defaults
To reset all settings and channels to their factory
default values:
default values:
1
Press Y and open the Setup menu.
2
Highlight Installation and press T. A new set of
Installation menu icons will appear.
Installation menu icons will appear.
3
Open the System Status menu, highlight System
Information, and press T.
Information, and press T.
4
Press C c to scroll through the menu bar to select
Factory Defaults.
Factory Defaults.
5
Enter your PIN code (or 0000 if no PIN code has been set).
Installation
Terrestrial
Channel Program
Channel Add/Delete
Signal Meter
Input Configuration
Antenna Tuning Mode
Signal Meter
Physical Digital Channel
4
Virtual Digital Channel
Done
Advanced
4-1
Signal Locked
0
0
Peak
System Information
System Status
Installation
System Information
Done
3.3.55.0
Jun 28 2007 - 01:10:27
RF350U
FW: 31
Software Version
System Information
Done
This window provides the ability to reset the TV
settings.Type in your PIN now (or "0000" if no
PIN has been set) to restore settings to their
factory default values.
Factory Defaults
40RF350U_EN.book Page 44 Thursday, July 5, 2007 5:42 PM