Toshiba ce27t11 Mode D'Emploi
11
Set up
Preparation
Basic Operation
Advanced Operation
Reference Section
Programming the Remote Control
CH RTN
SUR
ADV
ADV
MUTE RECALL
TV/VIDEO SURROUND
REC
TV/VCR
REW
FF
STILL LOCATE SWAP
STOP SOURCE
PLAY PIP
+
FAV
C.CA
PT
RESET
XD
S
EX
IT
-
FAV
VOL
CH
MENU
1
4
7
2
5
8
3
6
9
0
100
TV
VCR
TIMER
POWER
ENT
CABLE
MTS
●
This Remote Control is preprogrammed to operate TOSHIBA VCR’s.
●
To use VCR’s other than TOSHIBA models (or cable converter), perform the following procedures before
operating.
operating.
Number
buttons
buttons
ENT
Device
buttons
buttons
Controlling other brands of VCR’s and cable TV converters
1
Refer to the “
VCR code table
” (or “
Cable TV converter code
table
”) on pages 12 and 13 to find the code number that corresponds to
the brand name of your VCR (or converter).
If more than one number is listed, try each one separately until you find
the one that works.
the one that works.
2
Turn on the device (VCR or converter) you wish to operate with this
remote.
remote.
3
Press the matching Device button “VCR” (or “CABLE”) and ENT at the
same time until the Device button lights up. It indicates that the Remote
Control is in the program mode. Perform the following steps while the
back-light is on (about 20 seconds).
same time until the Device button lights up. It indicates that the Remote
Control is in the program mode. Perform the following steps while the
back-light is on (about 20 seconds).
4
Point the Remote Control toward the VCR (or converter) and press the
Number buttons to enter the three digit code number for your brand of
VCR (or converter).
–If the right number was entered, the VCR (or the converter) should
Number buttons to enter the three digit code number for your brand of
VCR (or converter).
–If the right number was entered, the VCR (or the converter) should
turn off.
–If the VCR (or the converter) does not respond to the Remote
Control, repeat steps 1 to 4 with another code number until the device
turns off.
turns off.
The back-light will blink to confirm the storage.
5
Press the Device button again to release the program mode.
VCR CODE
CABLE CODE
Notes:
●
You have to reprogram the Remote Control when you change its batteries.
●
Some newer VCR’s are capable of working on either of two remote codes. These
VCR’s have a switch labeled “VCR1/VCR2”.
If your VCR has this kind of switch, and does not respond to all the code numbers
for your VCR brand name, set the switch to another position (“VCR1” or “VCR2”)
and reprogram the Remote Control.
VCR’s have a switch labeled “VCR1/VCR2”.
If your VCR has this kind of switch, and does not respond to all the code numbers
for your VCR brand name, set the switch to another position (“VCR1” or “VCR2”)
and reprogram the Remote Control.