Mitsubishi wd-52527 Manuel Du Propriétaire

A peer-to-peer connection allows the IEEE 1394 devices 

in your TV network to talk to each other without the 
further need of TV intervention once the peer-to-peer 
connection is established.

For example, the TV can set up a connection for an IEEE 

1394 cable box that sends a program to be recorded 

to an A/V Disc or DVCR.  NetCommand will establish 
the connection between the two devices.  Once the 
connection has been established, the TV can be 
turned off or used to watch another device.  Recording 
from digital channels to a DVCR is also a peer-to-peer 
connection.  In this case, the TV is one of the devices in 
the peer-to peer connection.

NOTE: Analog or traditional (non-digital) devices can not 
be used for peer-to-peer connections.

A peer-to-peer connection is a current connection and 

cannot be setup as a delayed connection.

To establish a peer-to-peer connection:

1. Tune to source.

2. Press CONNECT or REC/CONNECT on the TV remote.

3. In the “Record to” section, review the destination 

device (example: DVCR) and duration.  Change if 

necessary.

4.  Press CONNECT or REC/CONNECT a second time to 

initiate recording.

NOTE:  Multiple peer-to-peer connections can 
occur simultaneously, sometimes with the same 
source device.  Also, please note that peer-to-peer 
connections are NOT listed on the Record List 
screen. 

When a peer-to-peer connection has been established, 
you can cancel the connection by highlighting the source 
device in the Device Selection menu.  Confirm that the 
on-screen icon for the peer-to-peer connection is in 
the Connection Section next to the TV icon, then press 
CANCEL.  The peer-to-peer connection will end and the 
destination icon will be removed.  If there is more than 
one peer-to-peer connection for the same device, all of 
the connections will all be canceled.