Mitsubishi wd-52527 Manuel Du Propriétaire

A. Connect the single set of stereo audio outputs to the TV only.  Use Edit NetCommand® to change the setup of this 

device.  In the Connection screen of “Change” make sure both audio and video for the TV input are check marked 
and neither the audio or the video for the AVR input are check marked.  This will allow the NetCommand system to 
use the TV outputs to transfer the device’s audio to the A/V Receiver.  See Edit NetCommand in the next chapter for 
details.

A. In most setups, analog audio is also output as digital audio, so no switching is required, and there is no need to 

connect the analog output.  In some circumstances, however, you may also need analog audio from the TV.  For 
example, MP3 audio is only output in analog format, so you must connect the TV’s 

analog AUDIO OUTPUT

 to the 

A/V Receiver if you want it to play MP3 audio.  Refer to your A/V Receiver user’s guide to find out how analog/

digital audio switching works.  

•  If your A/V Receiver’s remote control has an Analog/Digital Audio key, you can use the GUIDE key with the 

following models to control switching:

Mitsubishi M-VR900

Integra DTR-9.1

Denon AVR-2700

Kenwood VR-2080

  To make the switch, press the Device key on the TV’s remote control, and from the Device Selection menu, 

press the Audio key.  Then, with the A/V Receiver highlighted, press the GUIDE key to make the switch.

•  If you have some other A/V Receiver model, use the TV’s learn function to learn the code for the GUIDE key.  

Follow the instructions above for using the GUIDE key.

•   If your A/V Receiver has an Analog/Digital selection key on the front panel only, and not on the remote, then 

your only option is to use that key to perform switching.

Q. The front panel of my A/V Receiver is too tall or too convex for the IR emitter signal to reach the remote
control sensor of the A/V Receiver.  What can I do?
 A.  There are several possible solutions.

1.  Mount the IR Emitter on the top, front edge of the A/V Receiver over the remote control sensor.  Use tape to 

secure it in place.

2.  Mount the IR Emitter on the underside of the shelf above the A/V Receiver (if the A/V Receiver is in a cabinet).  

Use double sided tape to secure it in place.

3.  Some small stick-on emitters from other manufacturers may be compatible with this TV’s IR Emitter jacks.  These 

may be used instead of the supplied IR Emitters.

A. You can connect the video output of the A/V Receiver to an unused input on the TV.  Then use Edit NetCommand to 

“Add” this as an “Other” device, not an A/V Receiver.  On the “Connection” screen, indicate which TV input was used 

and check mark the video box.  Make sure the TV input audio box and both the audio and video boxes for the AVR 
input are not check marked.  You should also name this device so you can easily identify it on the Device Selection 
Menu.  You can also use Input 3 (Camcorder) on the front panel.

A. Yes, this item will appear twice in the Device Selection Menu.  Just add this unit once using the Component-1 and 

once using one of the S-video inputs.  Make sure you indicate that this is the same manufacturer for both.  We 
suggest that you connect stereo audio outputs with the S-video to the TV so that you do not need to use two inputs 
on the A/V Receiver.  If this is a NetCommand compatible HDTV receiver and HD or SD outputs can be switched by 

remote control, see Edit NetCommand in the next chapter for NetCommand control of this feature.