Mitsubishi ws-48513 Manuel Du Propriétaire

56

57

Setup Menu 

Edit NetCommand

®

Detailed information regarding Edit NetCommand is found 
in Chapter 3. The functions of Edit NetCommand are:

• ADD - Addition of new devices.

• CHANGE - Change or edit traditional devices and  IEEE  

 

1394 devices.

• DELETE - Delete a single device or delete the entire setup  

 

configuration.  After deleting, you will be able to start with  

 

the Initial NetCommand screen.

• REVIEW - Review all devices connected to the TV,  

 

 

including IEEE 1394 devices, and turn devices and unused  

 

inputs On or Off.

 
• INITIAL - Allows initial setup, in the event NetCommand  

 

setup was cancelled or if the entire configuration was    

 

deleted or not completed.

Icon Position 

Selecting the Icon Position screen allows you to arrange 
the device icon order on the Device Selection menu to 
your preferred sequence to make the operation of the TV 
easier.

Press ADJUST   ,  ,  , or    to highlight the icon to be 
moved and then press ENT(er).  Press ADJUST   ,  ,

 or    to move the icon to the desired position and then 

press ENT(er) to secure the icon in the new position.

Energy Mode

This feature allows you to save electrical energy when the 
TV is off and in the standby mode.  Standard mode uses 
more power but allows all of the background features to 
continue to operate.  Low mode saves power (using less 
than 2 watts), however, using this selection will restrict or 
turn off many of the background features.

If the Energy Mode is set to Low the following features 
of the TV will be restricted or unavailable when the TV is 
turned off (Note: The features will operate normally when 
the TV is powered On):

• TV controlled recordings, including “Record Later “  

 

 

recordings will not be possible.

• TV Time (clock) will be lost after approximately 48 hours.   

 

The clock will need to be reset through the Time menu.

•  The Timer function cannot be used to turn on the TV.

• IEEE 1394 functions that pass through the TV or IEEE 1394  

 

recordings from the TV or Ant-DTV will not be possible.

• The amount of time required to turn on the TV will increase  

 

to more than one minute.

Language

Display the on-screen menus in either English or Spanish 
(Español).  The first time you powered On your TV, you 
were requested to select an on-screen menu language.  
If you choose to change the selection, all menu text will 
immediately switch to the language of your choice.

Transport Menu

The Transport Menu is used by NetCommand® to control 

VCRs, DVDs, IEEE 1394 AV Disc, digital VCRs, and similar 
devices.  This menu can be turned off if you would rather 

not have it displayed.  The transport buttons on the 
remote control will continue to operate these devices.  

Setup Menu

Select Setup to perform the functions listed below.