Mitsubishi ws-48513 Manuel Du Propriétaire

Advanced Menu: Reset Factory Defaults, Convergence

Advanced Menu: Convergence

Figure 22

Select Advanced to perform the functions listed below.

Your Mitsubishi TV has three picture tubes which need to

be aligned to properly converge the projected light beams
on the screen. Each picture tube projects a single color of
red, blue or green.

During production, your TV was carefully adjusted to
properly align these colors. However, moving the TV, the

TV’s location in relation to the Earth’s magnetic poles,

and the passage of time can cause these adjustments to
change.

As a special feature, you have the ability to adjust the

red and blue light beams in reference to the fixed green
light beam. This process is called convergence. There
are two separate memories for convergence. One, for

SD 480i/480p signals; the other for HD 1080i signals. SD
convergence should be adjusted while watching an SD
source and HD convergence should be adjusted while
watching an HD source.

The TV should be fully warmed up before adjusting

Convergence. Turn the TV On and wait at least 30

minutes before starting adjustments.

Convergence Menu

Figure 24

When the Red and Blue crosshairs are properly
converged, the center-screen crosshairs will appear white.

You can press ADJUST , , or to move the Red

and Blue crosshairs. Press VIDEO to switch between Red
and Blue. Press AUDIO for the Advanced Convergence
screen, and see the next page for further instructions.

Reset Factory Defaults Menu

Figure 23

This allows you to reset the convergence to the original

factory settings. The message “Convergence reset
completed” will be displayed when the factory defaults
have been restored.

Red

Press ADJUST to converge the lines.
Press VIDEO to switch from Red to Blue.
Press MENU to go back.
Press CANCEL to delete changes.
Press AUDIO for Advanced Convergence.

��
��

��
��
��

��
��

Figure 22. Advanced Menu, Convergence

Figure 23. Reset Factory Defaults Menu

Figure 24. Red Convergence Menu