GCC 12 Manuel De Montage
54
54
S
ETTING AN
IP
ADDRESS ON THE PRINTER
If an IP address has already been set on your printer (usually by your network administrator)
you do not need to follow these steps. To check to see if a network address has been set:
you do not need to follow these steps. To check to see if a network address has been set:
1.
Turn the printer on.
2.
Press the On Line button to take the printer off line.
3.
Press the Menu button 8 times until you see the words “Printer Information” with the
word ‘configuration’ on the second line in the display.
4.
Press the Enter Key once. The printer will print a configuration page.
5.
Press the On Line button to take the printer back on line.
6.
If the printer already has an IP address you will see it in the TCP/IP part of the
Interfaces section of the Configuration Page. If the IP address is 0.0.0.0 then an IP
address has not been assigned.
•
Consult your network administrator to obtain a valid IP Class, Subnet Mask,
Address, Broadcast and Default Router Address for the printer.
To set your printer information do the following:
1.
Turn the printer on.
2.
Press the On Line button on the printer’s control panel to take the printer off line.
3.
Press the Menu button 7 times until you see the word “Interfaces” in the display.
Press the Enter button.
Press the Enter button.
4.
Press the Menu button until you see the word “TCP/IP” in the display.
5.
Press the Enter Button; you will see the word “Disabled” in the display.
6.
Press the + (plus) button. The word “Enabled” will appear in the display.
7.
Press the Enter button. An asterisk will appear to the right of the display; this
indicates that the setting has been saved.
indicates that the setting has been saved.
E
ACH TIME YOU MAKE A CHANGE
,
USE THE
+ (
PLUS
)
OR
- (
MINUS
)
BUTTONS TO CHANGE THE VALUES
. Y
OU WILL
NEED TO PRESS
E
NTER AND LOOK FOR THE ASTERISK TO CONFIRM THAT THE SETTING HAS BEEN SAVED
.
8.
Press the Menu Button until IP Class appears in the display. The Network Guide on
the CD-ROM can give you detailed information on Classification of Addresses. The
default is C.
the CD-ROM can give you detailed information on Classification of Addresses. The
default is C.
9.
Press the Menu button and set the Subnet Mask using the + or - buttons. Press
Enter when you have set the entire Subnet Mask and look for the asterisk to confirm
that the setting has been saved.
Enter when you have set the entire Subnet Mask and look for the asterisk to confirm
that the setting has been saved.
10. Press the Menu button and set the IP address. Press Enter to move from group to
group. Press Enter to save the settings.