Roland g-70 Manuel Du Propriétaire

G-70 Music Workstation 

r

After unpacking your G-70 –and before switching it on– you 
need to defeat the protection of its internal memory (a solid-
state hard disk) if you intend to save data in the internal 
memory. 

• Use a philips screwdriver to loosen the screws and remove 

the plastic cap.

• Slide the INTERNAL MEMORY PROTECT switch to the “

” 

position to unlock the memory.
(To once again lock the internal memory, slide the switch 
back to the “

” position.)

Note: Be sure to store the cap and the two screws in a safe 
place in case you need them again at a later stage.

(1) Insert the included power cable into the AC inlet and 

then plug it into an electrical outlet.

(2) Press the G-70’s [POWER¥ON] button located on the 

rear panel to switch it on.

(3) If you connected the G-70 to a mixing console, switch it on now.

(4) Switch on the amplifier, your active speakers or the keyboard amplifier(s).

(5) Use the [MASTER¥VOLUME] knob to set the G-70’s out-

put volume.

The information in the LCD display may be difficult to view 
after turning on your G-70 or after extended use. Your 
viewing angle or the current lighting conditions can also 
affect the appearance of the display. 

In such cases, use the [LCD¥CONTRAST] knob to the left of 
the display to adjust the contrast.

(1) Switch off all external devices.

(2) Use the G-70’s [POWER≈ON] button to switch it off.