Rollei Dk4010 Mode D'Emploi

 | Using Continuous Shooting Mode | Shooting Movies | Selecting Scenes to Automatically Set the Focus and Flash | [k] Using Self-Timer | Using Zoom (Wide-angle and 

Telephoto) | Using Flash | Adjusting Brightness | Setting Focus | Displaying Information on the LCD Monitor | Selecting the Number of Pixels (Image Size) and the Quality | Adjusting Image 
Colors and Other Settings | Switching Display Screen (Electronic Viewfinder and LCD Monitor) | Setting the exposure and focus during continuous shooting (Drive mode)

Contents (Top page) Detailed Contents

3

Press the shutter release button down 

half way to set exposure and focus.

The camera gives a short double-beep and the green shooting mark 
"Z" lights on the LCD monitor to indicate that the focus has been set.

4

Press the shutter release button down 

fully.

The camera emits the shutter sound and takes a picture.

B

Note

A flashing shooting mark "Z" indicates that the 
focus is not set. Press the shutter release button 
half way again until the shooting mark "Z" stays lit 
and the focus is set.

„

Pressing the shutter release button half way

When you press the shutter release button, it stops at a 
point on the way down to the fully pressed position. At this 
point, it is said to be pressed half way and the camera 
determines the focus in readiness for taking a picture. If 
you then continue pressing the shutter release button all  
the way down, the camera takes the picture.

B

Note

You can adjust the volume of the shutter sound. 
(Æ p.158)

A

Important

The camera will focus on subjects roughly 60 cm or further from the camera at the wide-
angle (

W) setting and roughly 2 m or further from the camera at the telephoto (T) 

setting. For subjects that are closer to the camera, use macro mode to take the shot. 
(Æ p.45)

Pipip

Not pressed

Pressed half way

Pressed fully
(starts picture
shooting)

Click