Enterasys csx400 Manuel De Montage
Chapter 4: Installation
4-14
CyberSWITCH CSX400 and CSX400-DC Installation Guide
Connecting the CSX400 to the Power Source
To connect the CSX400 to the power source, perform the following steps:
1.
Plug the power cord into the back panel of the CSX400.
2.
Plug the other end of the power cord into a grounded wall outlet.
3.
Verify that the PWR LED is on, indicating that the CSX400 is receiving power. After the
CSX400 runs a self test, the CPU LED blinks green indicating normal operation. If the LED
remains red, the processor is faulty; contact Cabletron Systems Global Call Center (refer to
CSX400 runs a self test, the CPU LED blinks green indicating normal operation. If the LED
remains red, the processor is faulty; contact Cabletron Systems Global Call Center (refer to
.)
4.
Refer to the QuickSET Configuration Guide to configure the CSX400.
NOTE
The CSX400 has a universal power supply. This allows you to connect the CSX400 to
power sources of 100–125 and 200–240 Vac, 50/60 Hz.
power sources of 100–125 and 200–240 Vac, 50/60 Hz.