Enterasys csx150 Mode D'Emploi
Small Office Remote Access Switch 351
S
YSTEM
V
ERIFICATION
Verifying IP RIP
command is used by a specific router to display the IP routing table. Substitute the equivalent
command for your IP router.
command for your IP router.
The steps to verify the operation of IP RIP output processing on a WAN interface are:
1.
Make sure that a dedicated connection between system and Router is up and operational. On
the system’s administration console:
the system’s administration console:
Type:
cs
<return>
If the connection to Router is displayed, the continue with the next step.
2.
Determine if Router has learned the route to 192.1.1.0 from the system. On the Router:
Type:
show ip route
<return>
If the route to 192.1.1.0 is displayed, the IP RIP output processing is operational.
If the route is NOT displayed, refer to
in the Problem
Diagnosis chapter.
V
ERIFY
IP RIP I
NPUT
P
ROCESSING
O
PERATIONAL
ON
A
WAN I
NTERFACE
To verify that IP RIP Input Processing (routes learning) is properly operational on a WAN interface,
the IP RIP processing must be successfully initialized.
the IP RIP processing must be successfully initialized.
The same example that is used in the previous section is used to verify IP RIP input processing on
a WAN interface.
a WAN interface.
To verify the operation of IP RIP Input processing on a WAN interface:
1.
Make sure that a dedicated connection between system and Router is up and operational. On
the CyberSWITCH administration console:
the CyberSWITCH administration console:
Type:
cs
<return>
If the connection to Router is displayed, the continue with the next step.
2.
Determine if system has learned the route to 192.1.2.0 from the Router. On the CyberSWITCH
administration console:
administration console:
Type:
ip route
<return>
If the route to 192.1.2.0 is displayed, the IP RIP input processing is operational.
in the Problem
Diagnosis chapter.
Dedicated Connection
Router
192.1.1.1
100.1.1.1
100.1.1.2
192.1.2.1
CSX150