Enterasys csx150 Mode D'Emploi
USER’S GUIDE
54 CyberSWITCH
2.
Turn on the administration console, and execute the communications program so that your
terminal emulator accesses the RS232 port connected to the system.
terminal emulator accesses the RS232 port connected to the system.
3.
During power-on initialization, the First Stage Boot (FSB) displays a brief inventory of the
system. The FSB then writes the following message to the administration console:
system. The FSB then writes the following message to the administration console:
Waiting for Commands:
During initial installation, no commands need to be entered at this point. Once this message is
displayed, the system waits 10 seconds before proceeding with the Second Stage Boot (stored
in flash memory). If this message is not displayed, and the Service LED is blinking, refer to the
displayed, the system waits 10 seconds before proceeding with the Second Stage Boot (stored
in flash memory). If this message is not displayed, and the Service LED is blinking, refer to the
chapter for instructions.
4.
When the Second Stage Boot (SSB) begins executing, it performs a series of diagnostic tests
called the power-on self tests (POSTs). Nothing is displayed while these tests are running
unless a failure is detected. In the unlikely event of a failure, messages are displayed on the
console screen. Immediately after the POSTs have been completed, a summary of available
resources and system information is displayed similar to the following:
called the power-on self tests (POSTs). Nothing is displayed while these tests are running
unless a failure is detected. In the unlikely event of a failure, messages are displayed on the
console screen. Immediately after the POSTs have been completed, a summary of available
resources and system information is displayed similar to the following:
If no First Stage Boot commands were entered, and valid system software is detected, the
Second Stage Boot begins to load the system software. Dots (...) are displayed to indicate
progress. The display will look like the following:
Second Stage Boot begins to load the system software. Dots (...) are displayed to indicate
progress. The display will look like the following:
5.
Log-in and password prompts will be displayed after completion of power-on initialization
(approximately 15 seconds after the “Booting System Software” message):
(approximately 15 seconds after the “Booting System Software” message):
The log-in for the system controls which class of commands users can access. A unique log-in
password protects each access level (“guest” or “administrator”). This lets managers assign
different responsibility levels to system users. Enter the following login:
password protects each access level (“guest” or “administrator”). This lets managers assign
different responsibility levels to system users. Enter the following login:
admin
6.
Follow the prompts to enter a new password. A password must be a 3 to 16 character string
without blanks. Passwords are case sensitive. If your software was previously accessed by your
distributor, your password will be admin (in lower case).
without blanks. Passwords are case sensitive. If your software was previously accessed by your
distributor, your password will be admin (in lower case).
A
CCESSING
THE
R
ELEASE
N
OTES
The Release Notes provide release highlights and important information related to this release that
should be reviewed before you begin the system’s installation and configuration.
should be reviewed before you begin the system’s installation and configuration.
The Release Notes are located on CD, and they are also located on the system’s FLASH file system.
SSB Ver: 001.003.001
4 MBytes DRAM Detected.
3 MBytes Flash Detected.
512 KBytes I/O DRAM Detected.
512 KBytes BUF DRAM Detected.
4 MBytes DRAM Detected.
3 MBytes Flash Detected.
512 KBytes I/O DRAM Detected.
512 KBytes BUF DRAM Detected.
Booting System Software...............
Successfully Loaded Release 7.1 Issue 8
Successfully Loaded Release 7.1 Issue 8
Administration session active
Enter login id:
Enter login id: