Enterasys micrommac 22es Manuel De Montage

Chapter 4: Troubleshooting Procedures

The following parameters must accurately reflect both the Micro-CS and 
the network environment in which it operates:

Verify the Micro-CS’s Internet address using the addr command.

If your network configuration does not support the factory defaults, 
verify the following parameters using the addr command:

The broadcast address.

The subnet mask.

The load/dump gateway address (which must be specified if the 
preferred load server host is located on another network or 
subnet).

The IP encapsulation type. Many systems have hardware Ethernet 
interfaces that are IEEE 802.3 compliant but very few actually do 
802.3 IP packet encapsulation. Use the default, Ethernet, unless 
you know absolutely that your LAN does 802.2/802.3 IP packet 
encapsulation.

H/W errors

The Micro-CS sensed a hardware error during 
message transmission or reception. This error 
indicates a fault with the Micro-CS network 
interface. Use the net command to isolate the 
problem (see Chapter 3).

Msgs from wrong host

The Micro-CS received a message from an 
incorrect host. This indicates that the 
Micro-CS received, and ignored, an 
unsolicited packet.

Rsp T/O’s

The Micro-CS never received a correctly 
formatted response from the correct host, or 
any response from any load server hosts.

Msgs of wrong type

The correct host sent a message to the 
Micro-CS, but the message was not a 
correctly formatted response to the 
transmitted request.