Output Solutions ccd-1021plus Mode D'Emploi
27
The key type/status is specified in character basis.
Each character programmed is by default of Normal
key type. A character of normal key type can have
associate status settings (add Shift/Control/Alternate).
Whereas a character of Scan Code type may not have
any associate key status settings.
Each character programmed is by default of Normal
key type. A character of normal key type can have
associate status settings (add Shift/Control/Alternate).
Whereas a character of Scan Code type may not have
any associate key status settings.
•
Normal Key Type: When this label is read, the
scanner will assume the following hexadecimal
digits are the ASCII code of the character being
programmed. And it will also clear all the
associate key status settings made to the
current character.
scanner will assume the following hexadecimal
digits are the ASCII code of the character being
programmed. And it will also clear all the
associate key status settings made to the
current character.
•
Scan Code : When this label is read, the
scanner will assume the following hexadecimal
digits are the scan code value of the character
being programmed.
scanner will assume the following hexadecimal
digits are the scan code value of the character
being programmed.
•
Add Shift : The Shift key will be sent together
with the character programmed.
with the character programmed.
•
Add Control (L) : The left Control key will be
sent together with the character programmed.
sent together with the character programmed.
•
Add Alternate (L) : The left Alternate key will
be sent together with the character
programmed.
be sent together with the character
programmed.
•
Add Control (R) : The right Control key will
be sent together with the character
programmed.
be sent together with the character
programmed.
•
Add Alternate (R) : The right Alternate key
will be sent together with the character
programmed.
will be sent together with the character
programmed.
For example, to program the Prefix Code to be “Ctrl-
Shift-B”, “C”, the programming sequence should be :
Shift-B”, “C”, the programming sequence should be :
1) “Prefix Code” label
2) “Add Control (L)” label
3) “Add Shift” label
4) “4” of the hexadecimal digit
5) “2” of the hexadecimal digit
6) “4” of the hexadecimal digit
7) “3” of the hexadecimal digit
8) “Validate”
2) “Add Control (L)” label
3) “Add Shift” label
4) “4” of the hexadecimal digit
5) “2” of the hexadecimal digit
6) “4” of the hexadecimal digit
7) “3” of the hexadecimal digit
8) “Validate”