Output Solutions ez-2 Mode D'Emploi
23
C. Technical Specification
EZ-2
EZ-4
Print method
Direct thermal
Max. paper width
2.36" (60 mm)
4.64" (118 mm)
Max. printing width
2.20" (56 mm)
4.09" (104 mm)
Max. print speed
2" per second (50.8 mm/Sec)
Dot density
203 dots per inch (8 dots per mm)
Power requirement
AC 13.5V ~ 16.0V; 3A ~ 5A.
DC 18.0V ~ 24.0V; 3A ~ 5A
AC 13.5V ~ 16.0V; 4A ~ 5A.
DC 18.0V ~ 24.0V; 4A ~ 5A
Sensor type
Label gap-sizing detector.
Print head life
50K meters printing distance when apply on Thermal Labels
Dimension
144 W x 215 H x 127 D mm ---With
internal label roll
144 W x 215 H x 320 D mm ---With
external label roll
198 W x 215 H x 127 D mm ---With
internal label roll
198 W x 215 H x 320 D mm ---With
external label roll
Working Environment
Operating Temperature: 40oF to 104oF (5oC to 40oC)
Storage Temperature: -40o to 140oF (-40oC to 60oC)
Humidity: 10% to 90% non condensing, free air
Specifications are subject to change without notice.
D. Communication Ports Specification
Parallel Port
Handshake
: DSTB to printer and BUSY to host.
Interface cable : DB25 Male (IBM-PC) 36 position parallel printer cable.
Pin out
Pin out
: PIN NO.
FUNCTION
TRANSMITTER
1
Strobe
host
2-9
Data 0-7
host
10
N/C
printer
11
Busy
printer
12
Paper empty
printer
13
Select
printer
14-16
N/C
17
Chassis Ground
18
N/C
19-30
Signal Ground
31
N/C
host
32
Fault
printer
33
Signal
ground
34-36
N/C
Serial Port
Serial port is set at the factory with 9600 baud-rate, no parity, 8 data bits, and 1 stop bit and uses XON/XOFF
protocol as well as RTS/CTS.
The connector is RS-232 DB9 female. The pin assignments are listed below.
protocol as well as RTS/CTS.
The connector is RS-232 DB9 female. The pin assignments are listed below.
PIN NO.
1
2
3
4
5
6
7
8
9
NAME
+5 V
TXD
RXD
DSR
GND
DTR
N/C
DTR
N/C
PDF created with FinePrint pdfFactory trial version