TomTom navigator 2 Manuel Complémentaire

3 

Tap Automatic, then enter your product code. The product code is printed 

on the product code card that is included with your product. 

TomTom NAVIGATOR will connect to TomTom using the wireless data 

connection and activate the map.

• Manually

To activate a map manually, do the following:

1. Tap Manual.

2. Go to this website: www.ttcode.com

3. Follow the instructions on this page to get an activation code.

4. Enter the activation code on your device to activate the map.

Once you have answered the questions and activated your map, NAVIGATOR 

displays the Driving View. The Driving View is shown in black and white until 

NAVIGATOR locates your current position. 

For more information about the Driving View, see Driving View on page 10.

Your GPS receiver must be outdoors to locate your current position. The first 

time you start NAVIGATOR, it can take up to 5 minutes to find your current 

position. If it takes longer than 5 minutes, make sure that you are in an open 

place without tall buildings or trees around you.

In the future, your position will be found much faster, normally within a few 

seconds.

Once NAVIGATOR has located your current position, the Driving View is 

shown in full colour and shows your position on the map.

It’s always a good idea to make a backup of the contents of your memory card. 

You can make a backup using TomTom HOME. 

For more information about TomTom HOME, see Using TomTom HOME on 

Now you are ready to get going. When you start to use NAVIGATOR, make 

sure you always drive safely by using the Safety preferences in the 

Preferences menu.

You can choose to use the safety lock. If the safety lock is enabled, only a few 

buttons and features are available while you are driving. When you are 

stationary, all the buttons and features are available.

You can also choose to turn the map display off. 

For more information, see Safety preferences on page 29.