TomTom ease Guide De Référence

41

affixed or applied upon the windshield or side or rear windows.”  Drivers in 

California should not use a suction mount on their windshield, side or rear win-

dows.

Note: this section of the California Vehicle Code applies to anyone driving in 

California, not just California residents.

Minnesota State Legislature Statutes Section 169.71, subdivision 1, section 2 

provides that “A person shall not drive or operate with any objects suspended 

between the driver and the windshield other than sun visors and rearview mir-

rors and electronic toll collection devices.”

Note: this Minnesota Stature applies to anyone driving in Minnesota, not just 

Minnesota residents.

TomTom Inc. bears no responsibility for any fines, penalties or damage that 

may be incurred by disregarding this notice.  While driving in any state with 

windshield mounting restrictions, TomTom recommends the use of the sup-

plied Adhesive Mounting Disk or its Alternative Mounting Kit, which includes 

multiple options for mounting TomTom devices on the dashboard and using 

the air vents.  See tomtom.com for more information about this mounting 

option.

This product contains a transmitter which must not be co-located or 

simultaneously operated in conjunction with any other transmitter.

This device complies with FCC radiation exposure limits set forth for an uncon-

trolled environment. In order to avoid the possibility of exceeding the FCC 

radio frequency exposure limits, human proximity to the antenna shall not be 

less than 8 inches (20 cm) during normal operation.

This equipment radiates radio frequency energy and if not used properly - that 

is, in strict accordance with the instructions in this manual - may cause inter-

ference to radio communications and television reception.

This device has been tested and found to comply with the limits for a Class B 

digital device, pursuant to Part 15 of the FCC Rules. These limits are designed 

to provide reasonable protection against harmful interference in a residential 

installation. This equipment generates, uses and can radiate radio frequency 

energy and, if not installed and used in accordance with the instructions, may 

cause harmful interference to radio communications. However, there is no 

guarantee that interference will not occur in a particular installation. If this 

equipment does cause harmful interference to radio or television reception, 

which can be determined by turning the equipment off and on, the user is 

encouraged to try to correct the interference by one or more of the following 

measures:

• Reorient or relocate the receiving antenna.

• Increase the separation distance between the equipment and the receiver. 

• Connect the equipment into an outlet on a circuit different from that to 

which the receiver is connected.

• Consult an experienced radio/TV technician for help. 

Changes or modifications not expressly approved by the party responsible for 

compliance could void the user‘s authority to operate the equipment.

This equipment was tested for FCC compliance under conditions that included 

the use of shielded cables and connectors between it and the peripherals. It is