Output Solutions ez-2000plus Guide De Référence
~Q±x - Row Offset Adjustment
Syntax
~Q±x
Parameter X=-100
~
+100
Description
If the printing does not appear in the same place on every label, this command instructs the
printer to print label formats. The “+n” move the position that the format specifies upward,
and the “–n” move the position downward.
printer to print label formats. The “+n” move the position that the format specifies upward,
and the “–n” move the position downward.
~Rx - Rotate printing
Syntax
~Rx
Parameter
x=label width (unit: mm), the input range is defined by the specification of printer models.
Description
Rotate the label format 180-degrees when printing (refer to page37). To return to the
original print direction, set the x value greater than the max width of model’s specification.
original print direction, set the x value greater than the max width of model’s specification.
~S,CHECK - Status immediate response command
Syntax
~S,CHECK
Parameter None
Description
Description
The HyperTerminal will show the status of printer in “aa,nnnnn<CR><LF>“ format.
aa = printer status information:
aa = printer status information:
00 – Ready
01 – Paper out
02 – Paper jam or miss gap
03 – Ribbon out
04 – Print head is up
05 – Rewinder full
06 – Memory is full
07 – filename can not be found
08 – filename is repeat
09 – Syntax error
20 – Pause
21 – In Setting Mode
22 – In Keyboard Mode
01 – Paper out
02 – Paper jam or miss gap
03 – Ribbon out
04 – Print head is up
05 – Rewinder full
06 – Memory is full
07 – filename can not be found
08 – filename is repeat
09 – Syntax error
20 – Pause
21 – In Setting Mode
22 – In Keyboard Mode
50 – Printer is printing
nnnnn = number of remaining labels, the value is from 00000 to 99999
*Note: Before using this command, the “^XSET,IMMEDIATE” (Set immediate response
on/off) command should be turned on.
*Note: Before using this command, the “^XSET,IMMEDIATE” (Set immediate response
on/off) command should be turned on.
~S,n - Analogue press control keys
Syntax
~S,n
Parameter
n = FEED
n = PAUSE
n = UNPAUSE
n = PAUSE
n = UNPAUSE
Description
This command can analogously press function keys on the printer.
Key in “~S,FEED” via COM port can generate the same action as pressing the “FEED” key.
Key in “~S,PAUSE” via COM port and the printing will be paused.
Key in “~S,UNPAUSE” via COM port and the printing will continue.
Key in “~S,FEED” via COM port can generate the same action as pressing the “FEED” key.
Key in “~S,PAUSE” via COM port and the printing will be paused.
Key in “~S,UNPAUSE” via COM port and the printing will continue.
~T - Print head testing
Syntax
~T
Parameter None
Description
Description
Print a pattern for the user to determine if the print head is damaged (refer to page39).
~V - Print Self-Test page
Syntax
~V
Parameter None
Description
Description
Print out the Self-Test page.
18