Grandstream gxw-4004 Manuel D’Utilisation
Grandstream Networks, Inc.
GXW400x User Manual
Page 22 of 36
Firmware 1.0.1.8
Last Updated: 5/2008
Port Forwarding
Forwards a matching (TCP/UDP) port to a specific LAN IP address with a specific
(TCP/UDP) port.
(TCP/UDP) port.
In addition to the Basic Settings configuration page, end users also has access to the Device Status page.
T
ABLE
8:
S
TATUS
P
AGE
MAC Address
The device ID in HEX format. This is needed for ISP troubleshooting. Note there are
separate MAC addresses for the WAN side and the LAN side. The LAN MAC address will
be used for provisioning and can be found on the label coming with original box and on the
label located on the bottom panel of the device.
separate MAC addresses for the WAN side and the LAN side. The LAN MAC address will
be used for provisioning and can be found on the label coming with original box and on the
label located on the bottom panel of the device.
WAN IP Address
Shows WAN IP address of GXW400x
Product Model
Contains the product model info.
Software Version
Program: This is the main software release. Boot and Loader are not changed often.
System Up Time
Shows system up time since the last reboot.
PPPoE Link Up
Shows whether the PPPoE connection is running if connected to DSL modem.
NAT
Shows type of NAT the GXW400x is connected to via its WAN port. It is based on STUN
protocol.
protocol.
Port Status
Displays relevant information regarding the individual FXS ports. Example:
Port
Hook
Registration
DND
Forward
Busy
Forward
Delayed
Forward
FXS1
On Hook
Registered
No
613
FXS2
Off Hook
Registered
No
614
FXS3
On Hook
Not
Registered
No
FXS4
On Hook
Registered
Yes
615
** FXS port 4 user has set Do Not Disturb.
FXS port 1 user has set his calls to be forwarded unconditionally to ext 613
FXS port 2 user has set his calls to be forwarded to 614 when his phone is busy.
FXS port 3 user is not registered with his SIP Server.
Advanced User configuration includes not only the end user configuration, but also advanced
configurations such as: SIP configuration, Codec selection, NAT Traversal Setting and other
miscellaneous configuration.
configurations such as: SIP configuration, Codec selection, NAT Traversal Setting and other
miscellaneous configuration.
Table 9: A
DVANCED
S
ETTINGS
Admin Password
Administrator password. Only the administrator can configure the “Advanced Settings” page.
Password field is purposely left blank for security reasons after clicking update and saved. The
maximum password length is 25 characters.
Password field is purposely left blank for security reasons after clicking update and saved. The
maximum password length is 25 characters.
Layer 3 QoS
This field defines the layer 3 QoS parameter which can be the value used for IP Precedence or
Diff-Serv or MPLS. Default value is 48.
Diff-Serv or MPLS. Default value is 48.
Layer 2 QoS
Value used for layer 2 VLAN tag. Default setting is blank.
STUN Server
IP address or Domain name of the STUN server.