NEC LCD2110 Manuel D’Utilisation
Troubleshooting
No picture
• The signal cable should be completely connected to the display card/computer.
• The display card should be completely seated in its slot.
• Power Button and computer power switch should be in the ON position.
• Check to make sure that a supported mode has been selected on the display card or
• The display card should be completely seated in its slot.
• Power Button and computer power switch should be in the ON position.
• Check to make sure that a supported mode has been selected on the display card or
system being used. (Please consult display card or system manual to change graphics
mode.)
mode.)
• Check the monitor and your display card with respect to compatibility and recommended
settings.
• Check the signal cable connector for bent or pushed-in pins.
• Check that the BNC/D-SUB button is in the correct position.
• Check that the BNC/D-SUB button is in the correct position.
Power Button does not respond
• Unplug the power cord of the monitor from the AC outlet to turn off and reset the monitor,
or simultaneously press the RESET and Power buttons.
Image persistence
• Image persistence is when a “ghost” of an image remains on the screen even after the
monitor has been turned off. Unlike CRT monitors, LCD monitors’ image persistence is not
permanent. To alleviate image persistence, turn the monitor off for as long as an image
was displayed. If an image was on the monitor for one hour and a ”ghost” of that image
remains, the monitor should be turned off for one hour to erase the image.
NOTE: As with all personal display devices, NEC Technologies recommends using a
screen saver at regular intervals whenever the screen is idle.
permanent. To alleviate image persistence, turn the monitor off for as long as an image
was displayed. If an image was on the monitor for one hour and a ”ghost” of that image
remains, the monitor should be turned off for one hour to erase the image.
NOTE: As with all personal display devices, NEC Technologies recommends using a
screen saver at regular intervals whenever the screen is idle.
Image is unstable, unfocused or swimming is apparent
• Signal cable should be completely attached to the computer.
• Use the OSM
• Use the OSM
™
Image Adjust controls to focus and adjust display by
increasing or decreasing the Fine control. When the display mode is changed, the OSM
Image Adjust settings may need to be re-adjusted.
Image Adjust settings may need to be re-adjusted.
• Check the monitor and your display card with respect to compatibility
and recommended signal timings.
• If your text is garbled, change the video mode to non-interlace and use 60Hz refresh
rate.
LED on monitor is not lit
(no green or amber color can be seen)
• Power Button should be in the ON position and power cord should be connected.
• Make certain the computer is not in a power-saving mode (touch the
• Make certain the computer is not in a power-saving mode (touch the
keyboard or mouse).
Display image has a green cast to it
• Select “TYPE” in the OSM Information menu and press the or Control button.
Display image is not sized properly
• Use the OSM Image Adjust controls to increase or decrease the H. Size.
• Check to make sure that a supported mode and signal timing has been selected on the
• Check to make sure that a supported mode and signal timing has been selected on the
display card or system being used. (Please consult display card or system manual to
change graphics mode or refresh rate.)
change graphics mode or refresh rate.)
13
LCD2110usersmanual
4/23/01, 10:44 AM
15