Sharp lc-26d40u Mode D’Emploi

•  When this function is not available, “NOT AVAILABLE” 

will display.

•  The still image automatically goes out after 30 minutes.
•  If you are using the freeze function and a broadcast 

activates the V-CHIP block, the freeze function will be 
cancelled and a V-CHIP block message will appear.

You can operate the connected AV products (AV 
Receiver, Cable Box, SAT tuner, DTV, VCR, DVD, 
LD) using the presetting manufacturer function of your 
remote control unit. 

Press FREEZE again to cancel the                   
function.

Allows you to capture and freeze an image from a 
moving image that you are watching.

Press FREEZE.

• A moving image is captured.

After the LED for your device lights up, 
press FUNCTION and DISPLAY at the 
same time to enter the code registration 
mode. The LED will blink.

Press FUNCTION until the LED for your 
device lights up.

After registering the code, the LED will stop 
blinking then turn off after one second. (If 
you perform an incorrect operation, the LED 
will blink quickly then turn off.)

Press 0–9 to enter the manufacturer code. 
(See page 36.)

•  Preset mode is fi nished once the LED no 

longer lights up.

In order to receive digital air broadcasts, you need a 
digital broadcast antenna. You can confi rm the antenna 
confi guration through the “SIGNAL METER” menu.

If necessary, adjust the direction of the antenna to 
obtain the maximum signal strength.

Press MENU and the MENU screen 
displays.

Press  /  to select 

 (SETUP).

Press 

/

 to select “SIGNAL METER”.

Press  / .

•  The strength of the digital signal is displayed. 

The signal information is based on the current 
channel.

Press EXIT to return to the normal screen.

3Y10101A.indb   35

3Y10101A.indb   35

2006/01/19   20:30:40

2006/01/19   20:30:40