Jet swivel band saw w Mode D'Emploi
10
4. Lift up on the motor and install the belt
around the pulley grooves, as shown in
Figure 4. Allow the motor to drop back
down, then push it down farther to tension
the belt. (For further information on belt
tension and belt position on the grooves,
see page 15.)
Figure 4. Allow the motor to drop back
down, then push it down farther to tension
the belt. (For further information on belt
tension and belt position on the grooves,
see page 15.)
5. Tighten the knob (A, Figure 3).
6. Close the pulley cover and secure it with the
pan head screw and hex nut.
Stock Stop
The stock stop is used for making multiple cuts
of the same length.
of the same length.
1. Insert the stock stop rod (A, Figure 5) into
the hole at the front of the base as shown.
2. Secure the rod by tightening the socket set
screw (B, Figure 5) with a 3mm hex wrench.
3. The stock stop is moved along the rod by
loosening the socket set screw (C, Figure 5)
with a 4mm hex wrench. The stock stop can
be reversed on the rod to accept slightly
longer lengths of workpieces. Tighten the
socket set screw (C, Figure 5) when the
stock stop is positioned as desired.
with a 4mm hex wrench. The stock stop can
be reversed on the rod to accept slightly
longer lengths of workpieces. Tighten the
socket set screw (C, Figure 5) when the
stock stop is positioned as desired.
The stock stop will mount into the hole at the
front or the back of the band saw, depending
upon the angle of cut being made (explained
more fully under “Miter Cuts”).
front or the back of the band saw, depending
upon the angle of cut being made (explained
more fully under “Miter Cuts”).
Figure 4
Figure 5