Maytag MHW6000X Manuel De Montage

Leveling your washer properly reduces excess noise and  

vibration.

Remove cardboard from beneath washer. 

Place a level on top edges of washer,  

checking each side and front. If not level, tip washer and 

adjust feet up or down as shown in steps 17 and 18, repeating 

as necessary. 

place level here

Grip washer from top and rock back and forth, making sure all 

four feet are firmly on floor. Repeat, rocking washer from side 

to side. If washer rocks, go to step 17 and adjust leveling feet. 

If all four feet are in firm contact with floor, go to Step 18.

Not Level

Not Level

Attach hot water hose to hot water inlet valve marked with a 

red ring. Screw coupling by hand until it is snug. Use pliers to 

tighten couplings an additional two-thirds turn. Repeat with 

cold water inlet valve.

IMPORTANT: To reduce risk of hose failure, replace the hoses 

every 5 years. Record hose installation or replacement dates 

for future reference.

n

  Periodically inspect and replace hoses if bulges, kinks, cuts, 

wear, or leaks are found.

Slowly turn on water faucets to check for leaks. A small 

amount of water may enter washer. It will drain later.

Secure drain hose to laundry tub leg, drain standpipe, or inlet 

hoses for wall standpipe with beaded tie strap.

Laundry Tub

Standpipe

Wall