Honda 690cc gx series v-twin ohv engine - electric start - remote throttle - gx690rtdw Mode D'Emploi
ENGLISH
STOPPING THE ENGINE
M
M
I
I
N
N
.
.
M
M
I
I
N
N
.
.
START
ENGINE
SWITCH
SWITCH
START
ENGINE
SWITCH
SWITCH
THROTTLE LEVER
O
O
N
N
CHOKE KNOB
O
O
P
P
E
E
N
N
C
C
L
L
O
O
S
S
E
E
D
D
O
O
N
N
O
O
N
N
M
M
I
I
N
N
.
.
M
M
I
I
N
N
.
.
THROTTLE LEVER
ENGINE SWITCH
OFF
OFF
5
Some engine applications use a remote-mounted throttle control
rather than the engine-mounted throttle lever shown here. Refer to
the instructions provided by the equipment manufacturer.
rather than the engine-mounted throttle lever shown here. Refer to
the instructions provided by the equipment manufacturer.
Turn the engine switch to
the ON position.
the ON position.
Operate the starter.
Turn the engine switch to the START
position, and hold it there until the
engine starts.
position, and hold it there until the
engine starts.
If the engine fails to start within 5
seconds, release the engine switch,
and wait at least 10 seconds before
operating the starter again.
seconds, release the engine switch,
and wait at least 10 seconds before
operating the starter again.
Using the electric starter for more than
5 seconds at a time will overheat the
starter motor and can damage it.
5 seconds at a time will overheat the
starter motor and can damage it.
When the engine starts, release the
engine switch, allowing it to return
to the ON position.
engine switch, allowing it to return
to the ON position.
Move the throttle lever away from the MIN. position, about 1/3
of the way toward the MAX. position.
of the way toward the MAX. position.
Warm up the engine for 2 or 3 minutes.
If the choke knob was pulled to the CLOSED position to start the
engine, gradually push it to the OPEN position as the engine
warms up.
engine, gradually push it to the OPEN position as the engine
warms up.
To stop the engine in an emergency, simply turn the engine switch
to the OFF position. Under normal conditions, use the following
procedure. Refer to the instructions provided by the equipment
manufacturer.
to the OFF position. Under normal conditions, use the following
procedure. Refer to the instructions provided by the equipment
manufacturer.
Move the throttle lever to the MIN. position.
Some engine applications use a remote-mounted throttle
control rather than the engine-mounted throttle lever shown
here.
control rather than the engine-mounted throttle lever shown
here.
Turn the engine switch to the OFF position.
If the fuel tank is equipped with a valve, turn the fuel valve to the
CLOSED or OFF position.
CLOSED or OFF position.
3.
4.
5.
6.
7.
3.
1.
2.
09/07/07 20:33:44 32Z6L600_005