TIC WRS010 Mode D'Emploi

Problem 

Please Check 

No Sound 

 

Transmitter is not initialized – Re-check the power is 
“on” at the transmitter and try changing “channels at 
the transmitter. 

 

Check the audio signal source both to and from the 
transmitter. Try another cable to ensure integrity. 

 

Check the receiver amplifier, if used, is powered “on” 
at the mains, is not on “mute”, has no headphones 
attached and that the Channels used for the 
transmitter/ exterior speakers (usually A or B) is in 
operation. 

 

Refer to the owners guide that came with your 
receiver amplifier. 

 

Check the “on” switch at the Remote Control to make 
sure the speaker is switched “on”. 

 

Check  volume control on your Remote Control is 
switched high enough for volume to be heard. 

 

Check the “Green” indicator light on your speakers to 
ensure they are receiving a signal. 

 

Ensure you speakers are receiving power. Red LED if 
batteries low. 

 

Ensure your speakers are receiving a signal. Green 
LED.  

No Sound from one 
speaker 

 

Check the “balance” control on your in house receiver 
amplifier is “equal”. 

 

Check all connections and cable to and from, or the 
integrity of the  transmitter source to the inoperable 
speaker. 

 

Check the batteries or power source(s) to the 
inoperable speaker.  

Left or Right 
speaker sound has 
intermittent or rough 
sound; the distance 
of the remote 
control volume 
controller becomes 
nearer  

 

Loudspeaker is flashing red light – the battery of the 
loudspeaker or remote control will soon be out of 
power. Please replace batteries. 

 

Check the “range” by temporarily bringing the exterior 
speakers closer to the transmitter source. 

 

Lift the transmitter height to see if this has any effect. 

One speaker 
sounds distorted, 
lower volume or 
“different”  

 

Follow same procedure as above for “No Sound”.