Manualsbrain.com
  1. Manuels
  2. Marques
  3. TIC
  4. WRS010
  5. Mode D'Emploi

TIC WRS010 Mode D'Emploi

Télécharger
Page de 12
The WRS010 wireless rock speakers full featured remote. Look for the Red led 
light to flash when any control is activated 
 
We equip each remote control transmitter with a MN21/23 or A23 battery or 
equivalent. These batteries require replacing when the remote controls distance 
becomes shorter or failures occur in the remote controls operation.  
E
E
x
x
t
t
e
e
r
r
i
i
o
o
r
r
 
 
I
I
n
n
s
s
t
t
a
a
l
l
l
l
a
a
t
t
i
i
o
o
n
n
…
…
 
  
1.  Carefully unpack your new TIC WRS010 outdoor wireless rock 
speakers and inspect all components as previously described. 
2.  Don’t forget to test your new unit prior to exterior installation.
 
3.  Carefully connect the mains 110/220v power cord to the broadcast 
transmitter placed near your receiver amplifier source. 
4.  Connect your broadcast unit to your chosen receiver amplifier with 
either the 3.5mm jacks direct or the with the color coded phono, (RCA) 
type plugs supplied. 
5.  Carefully connect the mains 110/220v power cord to your WRS010 
rock speakers. (First, prior to battery trial) 
6.  Attach any input devices, CD, MP3’s etc. as desired. 
7.  Power up your in house receiver/ amplifier and then the broadcast unit 
checking for “on” led signal lights. 
8.  Switch your wireless rock speakers “on” using the silicone covered 
rocker switch at the base of the unit checking for the Green signal 
source led light on. 
9.  Switch your wireless rock speakers “on” using the Remote Control on / 
off switch. 
10.  Test the unit using as many “modes” of operation as possible. Try 
changing the broadcast frequency channels at the transmitter to check 
for clearer reception alternatives. (CH on the transmitter). 
11.  When all is satisfactory try the batteries only, disconnecting the mains 
power cord accordingly.