Thetford 6063 Mode D'Emploi

Within 20 seconds the flame will go out, indicating
the safety lock-out circuit is operational. Reconnect
the wire to the ignition module upon completion of
the test.

The Norcold refrigerator doors provide slots for in-

serting decorative panels. Installation of the panels is
accomplished by removing the handle assembly, in-
serting the decorative panel, and re-inserting the
handle assembly. This procedure applies to both
doors. (See Figure 12)

The frame slots are designed to accept panel thick-

ness up to 3/16" maximum.

TABLE 4
PANEL DIMENSIONS

662, 663

6162, 6163

682, 683

6182, 6183

Upper

Door

19 11/16" x 16"

19 11/16" x 16"

Lower

Door

19 11/16" x 32 1/4"

19 11/16" x 39 1/4"

INSTRUCTIONS 

1. Prepare panel by cutting to size indicated in ac-

companying chart. (See TABLE 4) 

2. Remove handle assembly  (A)  by removing four

screws (B). (See Figure 12) 

3. Slide panel into frame slots. 
4. Replace the handle assembly.

Your refrigerator is equipped with convertible hinges

which allows the door swing to be changed at any-
time.
TOOLS REQUIRED 

Phillips Screwdriver - Size #2
Two Slotted Screwdrivers

REMOVING THE DOORS 

1. Remove all items of food, juices, etc., from the

doors. Remove the juice rack and storage bins.
Close both doors before removing hinge pins. 

2. Remove the top hinge pin using one of the slot-

ted screwdrivers. Remove the center hinge pin
(both pieces) using the two slotted screwdriv-
ers; one on each end of the pin. Lastly, remove
the bottom hinge pin. Be sure to save the pins
for reassembly later. (See Figure 19) 

3. Remove the upper door by opening the door

slightly and pulling the bottom of the door away
from the refrigerator. Allow enough room to
slide the door down off of the upper hinge pin
shoulder. (See Figure 13)

Ignition Module

Electrode Wire

Figure 11

Figure 12

Figure 13