Sonance ST2432D Manuel De Montage

Page 7

ST2432D Series

960.066 Rev # 1

the fi xed hinge into the slot provided on the side of the
backbox as shown in

Figure 18, and THEN inserting the

spring-loaded hinge in the opposite slot on the backbox,
as shown in

Figure 19.

NOTE: Once both hinges are inserted, the SpeakerTile
will swing like a trap door.

7. If not previously done, run speaker wires or conduit (as

per local Building Code requirements) into the selected
mounting location. Fasten and seal as required. Connect
the speaker wires to the correct (+) and (–) SpeakerTile
terminals and select the required power tap. Insure that
all connections and wiring runs are in compliance with
required codes and regulations.

IMPORTANT: To avoid any noise or damage to the
system when in operation, be sure speaker wires or
other objects are not in contact with the back of the
SpeakerTile surface.

8. Remove the protective cardboard from the front of the

SpeakerTile. Move the latch to the open position, swing
the SpeakerTile into the backbox and close the latch,
making sure the SpeakerTile is secured. See

Figure 20.

15/16” CEILING GRID: FLUSH OR TEGULAR
MOUNT INSTALLATION WITH BACKBOX

NOTE: The 15/16” tegular mount arrangement requires
the diaphragm front surface to be factory-routed in
order to drop below the ceiling grid.

1. Place the ST2432D SpeakerTile on a clean work area

with the fl at surface facing down. Remove all four Tegu-
lar Brackets (see

Figure 1 on page 2).

2. If not previously done, run speaker wires or conduit

(as per local Building Code requirements) into the se-
lected mounting location. Fasten and seal as required.
Connect the speaker wires to the correct (+) and (–)
SpeakerTile terminals and select the required power
tap. Insure that all connections and wiring runs are in
compliance with required codes and regulations.

Figure 17

Figure 18

Figure 19

Figure 20