Aethra d2000 lite Manuel D’Utilisation
ISDN TESTER AND ANALYZER D2000
PRO
/D2000Lite/D2000 USER’S MANUAL
6
Select AUTOMATIC TESTS.
The following window appears:
7
Select the type of test.
2.3. Performing an Access Test
This test allows to verify, automatically, in distinct sequences the following access
parameters:
parameters:
1
Layer 1
2
Layer 2 configuration
3
Layer 3 (bearer and teleservices)
4
Supplementary services
5
B channels
Setting appropriately the parameters above-mentioned, the user can decide the test
sequences to perform. Setting the value “Automatic”, the device will carry out a
complete test sequence, checking all the parameters regarding the interested level.
sequences to perform. Setting the value “Automatic”, the device will carry out a
complete test sequence, checking all the parameters regarding the interested level.
If it is chosen: “L2: Point to Point” and / or “L3: User”, the relative
values must be programmed before in the COMMON SETUP
page.
values must be programmed before in the COMMON SETUP
page.
The test sequence configured can be saved with a name defined by the user, in
order to be recalled for future uses. See chapter 4 for further information.
order to be recalled for future uses. See chapter 4 for further information.
26
CHAPTER 2 - PERFORMING AN AUTOMATIC TEST