Aethra avc500 Mode D'Emploi

 

 

A. Status of MCU manager 
By selecting the “Conference Status” icon a window will appear, with information about connection settings of local terminal. 
It’s moreover possible to: 

Select “Duration” icon to access MCU timing management page 

•  It’s possible to select “No time limits” or a time for MCU conclusion 

•  “Close Now” will immediately close the MCU 

•  “OK” to confirm choices 

•  “Cancel” to discard changes 

Select “Broadcast” 
 

B. Status of MCU “Terminal n.” 
By selecting the “Conference Status” icon a window will appear, with information about connection settings of terminal, 

number of connected remote terminals, kind of call (outgoing/incoming), terminal number. 
It’s moreover possible to: 

 

Select “Broadcast”, with disconnected terminals too 

 

Select the “

” icon, with connected terminals only, to visualize connection diagnostics 

 

Choose between “Always accept” or “Refuse” incoming IP or ISDN calls, with disconnected terminals only. 

 

Choose “Control Number” for ISDN, to insert the only number allowed to join the conference for that terminal. 

 

The “

” icon closes the page. 

There are two ways to end a multiconference:  

1.  From the full-screen video page, press the remote control DISCONNECT key 

•  The “Cancel” icon closes the page without performing any operation 

•  By means of arrow keys “UP” and “DOWN” you can select and disconnect a participant 

•  “Close Now” icon  will immediately close the whole MCU (disconnection of all terminals) 

2.  From the multiconference management interface, select the “Menu” icon on the status bar and press OK. 

 
In both cases the System shows: 

•  A message asking confirmation for the multiconference end 

•  A message asking whether to save in the Phonebook all information needed to repeat the multiconference, with an 

editable “Conference name” 

 

73