Viking Range vcqs001ss Guide De Montage

Page de 6
9
Service Information
If service is required:
1.
Call your dealer or authorized service agency.  The name
of the authorized service agency can be obtained from the
dealer or distributor in your area.
2.
Have the following information readily available:
a. Model number
b. Date purchased
c. Name of dealer from whom purchased
3.
Clearly describe the problem that you are having.
If you are unable to obtain the name of an authorized service
agency or if you continue to have service problems, contact Viking
Range Corporation at (888) 845-4641 or write to:
VIKING RANGE CORPORATION
PREFERRED SERVICE
111 Front Street
Greenwood, Mississippi  38930 USA
Record the information indicated below.  You will need it if service
is ever required.  
Model Number - 
Date of Purchase
Date Installed
Dealer’s Name
Address
If service requires installation of parts, use only authorized parts to
ensure protection under the warranty.
KEEP THIS MANUAL FOR FUTURE REFERENCE
8
Cleaning and Maintenance
After use, clean up the ashes which have fallen through the fire grate
into the bottom.  They can be removed through the bottom draft
door with the ash tool.  Do not let the ash build up, this will hinder
the air flow through the bottom draft door.
Your cooker can be placed anywhere outside your home.  The cooker
can be used year round.  Cold weather or rain will not affect the
quality of cooking.  
Battery Replacement (if applicable)
The side burner is equipped with a battery for the electronic ignition.
It is located to the right of the side burner knobs under the control
panel.  The battery location is shown on the control panel.
To replace the battery:
1.  Slide out the drip tray.
2.  Locate the round black cap which is inside the burner box under the
battery symbol on the control panel.
3.  Unscrew cap.  Battery is snapped in the cap.
4.  Replace the battery by connecting corresponding post to post
inside burner box.
5.  Snap cap on battery and screw back into slot underneath control
panel.
Drip Tray (If applicable)
The drip tray pan should be removed and cleaned after each use.
Allow the drippings in the drip try pan to cool completely before
removing.  Place the pan in hot, soapy water to clean.  Wipe up any
debris that may have collected in the drip tray with a hot, soapy towel.
Dry and replace drip tray pan before next use.