Lorex lw2902 Mode D'Emploi
30
Motion Recording
Use Motion Recording to have the system only record when motion is detected by one of the
cameras. The camera that appears on-screen is the only camera that is recording.
cameras. The camera that appears on-screen is the only camera that is recording.
To enable Motion Recording:
1. Press the Motion button. “AUTO REC” will light up
on the LCD receiver.
2. Perform one of the following:
Enable Quad Mode (
recommended
): Press the
Quad button. When motion is detected, the
system will display the triggered camera on-
screen.
system will display the triggered camera on-
screen.
When motion recording is complete, the
view will return to Quad Mode.
Enable Auto Sequence Viewing Mode: Press the CHANNEL—A button. When motion is
detected, the system will display the triggered camera on-screen. When motion
recording is over, Auto Sequence Viewing Mode will continue as normal.
detected, the system will display the triggered camera on-screen. When motion
recording is over, Auto Sequence Viewing Mode will continue as normal.
Change channels manually: Press the CHANNEL—M button on the wireless receiver or
remote control to select a channel.
remote control to select a channel.
3. Press the Motion button again to stop Motion Recording. “AUTO REC” will turn off on the
receiver.
Figure 7.3 Recording triggered by motion during the Motion Recording
R
R
E
E
C
C
A
B
ATTENTION
: If you manually select a channel while the system is in Motion Recording
Mode, motion recording will
ONLY
apply to the selected channel
. For example, with
Motion Recording enabled, you manually select channel 3; if motion were to occur in
view of camera 1, the system would NOT RECORD video from channel 1.
view of camera 1, the system would NOT RECORD video from channel 1.