Lorex sg620 Fascicule

Page de 2
MODEL – SG620
Simulated (Dummy) Dome Camera
Fresh batteries will power the simulated security 
camera’s indicator for about 4 months. When the 
indicator dims or stops flashing, replace the 
batteries
Warning: Dispose of old batteries promptly and 
properly. Do not burn or bury them
Caution: If you do not plan to use the simulated 
security camera with batteries for a month or 
more, remove the batteries. Batteries can leak 
chemicals that can destroy electronics parts
INSTALLING THE SIMULATED DOME 
SECURITY CAMERA
1. Using the mounting base plate as a template, 
use a pencil to mark the position of the two 
screw holes on the mounting location
2. Drill two 1 inch holes in the marked positions
3. If necessary, insert the two supplied
drywall anchors into the screw holes
4. Insert a 1 inch screw through each
of the two screw holes in the mounting base
plate and into the mounting surface, then 
tighten the screws.
5.Twist the top of the dome camera (with the 
batteries installed) onto the base plate 
Battery
Compartment 
-
+
-
+
Mounting
Base Plate
INTRODUCTION
Your Lorex Simulated Security Dome Camera is 
an affordable and effective theft deterrent device. 
It looks like a real surveillance camera with its 
flashing red indicator and dome construction. You 
can mount the simulated security camera in a 
visible area on a ceiling to deter possible thieves 
and intruders.
Your simulated security camera comes with a 
wall/ceiling mount plate, two screws and two dry 
wall anchors.
INSTALLING BATTERIES
Your simulated security camera requires two “C” 
batteries (not supplied) for power.
Cautions:
• Use only fresh batteries of the required size and
recommended type
• Do not mix old and new batteries, different types
of batteries (standard, alkaline, or rechargeable),
or rechargeable batteries of different capacities
Follow four steps to install batteries:
1. Open the dome camera by twisting off the
mounting base plate
2. Unscrew the battery compartment.
3. Place the batteries in the compartment
as indicated by the polarity symbols
(+ and -) marked inside.
4. The red indicator at the top of the dome 
camera will flash.