Bizfon 2000 Guide De Montage
Bizfon Manual I: Installation Guide
Step 2.4: Internet Configuration Wizard
Uplink Configuration
Select the desired WAN Interface Protocol and enter the WAN Interface Bandwidth to as-
sure the quality of IP calls.
Fig. I-19: Internet Configuration Wizard - Uplink Configuration
If the available bandwidth is used to the point where the quality of an additional IP call
would suffer, then new IP calls are rejected.
The bandwidth provided by your ISP must be specified for both Upstream and Down-
stream fields. The default entry in both fields is 10000, the maximum bandwidth of the 10
MB uplink module. For basic DSL and cable modem service in the United States, typical
values are 300 for Upstream and 1500 for Downstream.
The Min Data Rate text field is used to specify the amount of bandwidth reserved for data
applications. The value entered here needs to be smaller that the value specified for Up-
stream Bandwidth.
Specify the WAN Interface Protocol by choosing between available WAN interface proto-
cols: PPPoE (Point to Point over Ethernet), PPTP (Point to Point Tunneling Protocol) and
Ethernet. Use Ethernet for DHCP or static IP.
would suffer, then new IP calls are rejected.
The bandwidth provided by your ISP must be specified for both Upstream and Down-
stream fields. The default entry in both fields is 10000, the maximum bandwidth of the 10
MB uplink module. For basic DSL and cable modem service in the United States, typical
values are 300 for Upstream and 1500 for Downstream.
The Min Data Rate text field is used to specify the amount of bandwidth reserved for data
applications. The value entered here needs to be smaller that the value specified for Up-
stream Bandwidth.
Specify the WAN Interface Protocol by choosing between available WAN interface proto-
cols: PPPoE (Point to Point over Ethernet), PPTP (Point to Point Tunneling Protocol) and
Ethernet. Use Ethernet for DHCP or static IP.
WAN IP Configuration page
For Ethernet, clicking Next will display the
. If PPPoE is the
selected WAN Interface Protocol, the next page will be
. For PPTP
WAN Interface Protocol, PPP/PPTP Configuration page will follow the WAN IP Configu-
ration.
ration.
WAN IP Configuration
Your Internet Service Provider (ISP) should provide this information.
•
Assign automatically via DHCP - The parameters are set automatically by the ISP.
This is common with cable modem and DSL service.
This is common with cable modem and DSL service.
•
Assign Manually requires the administrator to enter the external IP Address, the cor-
responding Subnet Mask, and the IP address of the Standard Gateway. This is
common when you have a static IP address with your ISP.
responding Subnet Mask, and the IP address of the Standard Gateway. This is
common when you have a static IP address with your ISP.
Bizfon2000 and Bizfon4000; (SW Version 4.1.x)
24