Bizfon 680 Mode D'Emploi
Section 1 Installing Your Bizfon 680
Bizfon Administrator’s Guide
7
1. Connect the lines from the wall jack to the ports on the
Bizfon 680 labeled “INCOMING TELEPHONE LINES”.
2. Connect the lines from your telephone extensions to the
ports label “EXTENSIONS”.
Connect the telephone that is to be extension 201 to the port
labeled “201” and continue with each phone until all are
connected.
labeled “201” and continue with each phone until all are
connected.
You can connect a fax machine to any extension on the
Bizfon 680, but do not connect a modem.
Bizfon 680, but do not connect a modem.
3. After you have connected the phone lines and extensions,
plug in the power cord and wait until you hear “The Bizfon
is ready . . .”
is ready . . .”
Run the diagnostics as described in the next section.
Running Diagnostics
After connecting your phone lines and telephones, run diagnos-
tics to ensure that the Bizfon 680 is working optimally.
tics to ensure that the Bizfon 680 is working optimally.
NOTE: You cannot use the Bizfon 680 for calls during
diagnostics.
1. Press the blue button in the center of the Bizfon 680. You
hear:
“Welcome to the Bizfon diagnostics. Note that
during the diagnostics, the Bizfon may not be
used for calls. To run diagnostics on incoming
telephone lines and telephones, press the button
again.”
during the diagnostics, the Bizfon may not be
used for calls. To run diagnostics on incoming
telephone lines and telephones, press the button
again.”
2. Push the button again. You hear:
“Now running the incoming telephone lines test.
The LEDs for each incoming line flash if a dial
tone is detected. Each line is retested every few
The LEDs for each incoming line flash if a dial
tone is detected. Each line is retested every few