Clarity c4105 Mode D'Emploi
16
17
Redial/Pause
Press the RD/P button to redial the last number dialed. Pressing the RD/P but-
ton while storing a telephone number will insert a four (4) second pause. This is
commonly used when storing both the telephone number and an extension or
PIN number.
Press the RD/P button to redial the last number dialed. Pressing the RD/P but-
ton while storing a telephone number will insert a four (4) second pause. This is
commonly used when storing both the telephone number and an extension or
PIN number.
Battery Back-up
Installing four (4) AA Alkaline batteries into the desk/wall mount bracket
attached to the telephone base will offer you a limited amount of time to con-
tinue operating your telephone in the event of a power failure.
Installing four (4) AA Alkaline batteries into the desk/wall mount bracket
attached to the telephone base will offer you a limited amount of time to con-
tinue operating your telephone in the event of a power failure.
To Install Battery Back-up Batteries
1. Disconnect telephone line cord and remove desk/wall mount bracket from
1. Disconnect telephone line cord and remove desk/wall mount bracket from
telephone base.
2. Disconnect battery back-up connector from the telephone base.
3. Install four (4) AA Alkaline batteries with negative (-) end of battery touch-
3. Install four (4) AA Alkaline batteries with negative (-) end of battery touch-
ing the spring.
4. Connect battery back-up connector to terminal on bottom of phone base.
5. Install desk/wall mount bracket to telephone base.
5. Install desk/wall mount bracket to telephone base.
To Replace Battery Backup Batteries
1. Disconnect telephone line cord and remove desk/wall mount bracket from
1. Disconnect telephone line cord and remove desk/wall mount bracket from
telephone base.
2. Disconnect battery back-up connector from the telephone base.
3. Remove batteries from desk/wall mount bracket.
4. Install four (4) AA Alkaline batteries with negative (-) end of battery touch-
3. Remove batteries from desk/wall mount bracket.
4. Install four (4) AA Alkaline batteries with negative (-) end of battery touch-
ing the spring.
5. Connect battery back-up connector to terminal on bottom of phone base.
6. Install desk/wall mount bracket to telephone base.
6. Install desk/wall mount bracket to telephone base.
After installing the four (4) AA Alkaline batteries please
refer to the chart below:
refer to the chart below:
Power Supply
Power LED Status
AC adapter and
Steady Green
good batteries
AC adapter and
Steady Red
no batteries
Power failure and
Slow flashing red
good batteries
Power failure and
Fast flashing red
bad batteries
USING YOUR TELEPHONE
Placing a Call
1. Press the TALK button (TALK button will illuminate GREEN) and dial the
1. Press the TALK button (TALK button will illuminate GREEN) and dial the
number you wish to call.
2. To end the call press the TALK button or place the handset in the base.
Answering a Call
If the handset is out of the cradle, press the TALK button.
If the handset is out of the cradle, press the TALK button.
If the handset is in the cradle, simply lift the handset to answer.
Note: Refer to BOOST Clarity Power and Volume Control for information on
adjusting volume controls on Page 15.
adjusting volume controls on Page 15.
Last Number Redial
The last number dialed (up to 32 digits) is stored in the redial memory until
another number is dialed.
The last number dialed (up to 32 digits) is stored in the redial memory until
another number is dialed.
To use this feature:
1. Press the TALK button.
2. When you hear the dial tone, press the RD/P button.
3. The phone will automatically dial for you.
2. When you hear the dial tone, press the RD/P button.
3. The phone will automatically dial for you.